engine problems?..

[Jonny J]

Ok. so I fixed my boost leak.. But now I have a couple issues... My turbo spools up, kicks in boosts. But my a/f ratio goes lean. But my engine doesn't stall or anything? Is this normal? And the guy before me put a stage 2 clutch in and we had to replace the slave cylinder and now after bleeding it that day I have to keep constantly bleeding it or else my car won't go into gear.. I was told that adjusting the clutch might fix it? Also, replaced relay fuses but my dash lights still won't work. And lastly where could I pick up a service manual for my car? Ididn't get one when I bought it

 

[ruthlessriderz]

what is your a/f ratio when idle and wot? you dont want the car at lean for too long, it can in time damage the motor. i had the same problem and it ended up being my clutch master, but i would try and adjust it on the clutch pedal before you purchase a new one, are you building up any pressure at all?

 

[cianfar]

you can get a Chilton or Haynes on Amazon or Ebay for about 30 bucks

 

[boostront]

I would say the clutch problem would be your clutch master cylinder since you say you have replaced the slave already.Look under your dash where it meets the clutch pedal and against the fire wall around it for leaks.Mine went out and flooded the drivers side floor board with fluid.