check my bearings

[crimsondragon]

Disassembled a built short block I bought from a local. Just wanted your opinions to see what you guys think. Personally they look pretty good and nothing abnormal except there seems to have been some dirt and contamination on a few of the bearings. There were some deep grooves I could feel. Listed from 1-4. I plan on just getting new bearings and throwing them in.

Here are the rods listed 1-4. Everything on the crank seems to check out. All the rod journals are spot on at 1.7707". The main journals are measured anywhere from 2.2431" to 2.2436" with a out of round of no more than 0.0002".

 

[BogusSVO]

How many miles on the build?

What was the reason for pulling the engine apart?

How are the rod bearings?

 

[crimsondragon]

How many miles on the build?

What was the reason for pulling the engine apart?

How are the rod bearings?

Not sure on the miles. I bought it off a local who parted out the car that they bought off someone else. They claimed 3000 miles or less. I pulled it apart because I know nothing about this motor and didn't want to throw this motor in without at least gaining a bit of knowledge on how well it was assembled. The rod bearings are the last 4 pictures shown.

 

[BogusSVO]

Looks like you have something decent to work with.

Clean the crank oil galleys the best you can. and go on with the build.

 

[crimsondragon]

Thanks Bogus.