anything else i need?

[dansan1988]

So I am building a stock 6 bolt, need some help to see if I need anything else...

I have
Block
Crank
Pistons
Rods
Main and rod bearings
Piston rings
Head studs
Main studs
Bsek
Full top end and bottom end gasket and seal kit
Oil squirters
New viton valve guide seals...

Need...
Core plugs
Valve guides(?)



Anything else you can think of?

 

[bvass]

you need to check the valve guides and replace or knurl them if needed. I would get a brand new OEM front case (oil pump), water pump, idler and tensioner pulleys for the t-belt. You will also need assembly lube, piston ring grinder, and plastigage to measure bearing tolerances.

 

[dansan1988]

I have a perfectly good front case and gears, just need to clean it fue to being on a shelf for months, new t belt and tensioners as well. I will get my guides checked out to see if they are still good. The head is still stock, stock mill and everything else, valves never been taken out of the head.