weasel1G
Proven Member
- 231
- 47
- Aug 26, 2015
-
Columbus,
Ohio
Very nice build. You have me reconsidering getting rid of my A/C on my 1G, with tucking the lines. Great work
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Awesome build sir. Do u mind sharing tips and tricks on how you did your wire tuck? What did u use instead of plastic loom. Did u hewtshrink the ends? Looks very clean and profesional.
You're a better man than most of us. That's work ,but the car looks flawless as a result. I'm surprised you did not creat a cold air setup . Unless your hood is vented I can't remember.Well it runs thankfully . Did so much wiring work wasn't sure if it was all good or not. My power steering res had a pin hole leak some where so I'm just addressing that. Also one of my RCI injectors are not opening, it was doing the same thing when I put it away. Musta put 30 hours into it this past weekend, had to see if it would start fine, damn thing is so time consuming .
View attachment 304038
Cold start video I did this morning, keep in mind haven't set base timing, tho it's close or done a BLT. After listening to the video I tightened alt belt and exh mani studs.