I finally got my car on the road after putting my engine into this new shell. After driving around I noticed a hard jerking and loud bang while driving in 1st or 2nd gear at very low rpm's. It happens when I put slight pressure on the gas pedal, and when kept steady with slight pressure at low...
I have a 91 Talon awd with a 4 bolt rear. There has been a loud knock that I hear and feel in the rear end when I lift and engage the clutch into gear. I was told it was the carrier bearing bushings. I took the driveshaft off, and yes the bearings were totally shot. Luckily I have a spare which...
I have a v3 lite dsmlink I just bought. I have power to the car, key turned to "on", both ends of the usb datalogging cable attached. I try to click connect and keep getting, ports in use by "unknown application". And also no response recieved! I've tried both usb ports. I have a 1g and have it...
Don't know where this connector goes too. It's on the passenger side and it's origin is from the positive battery terminal part of the harness. It is 91.
Looking for a -8an hose with two female fittings to attach to my fuellab fuel filter with-8an male end to my fuel rail with -8an male end. Searched google but i'm having no luck.
How are you guys who are using the same setup, -8an fuel lines to connect to stock fuel filter. I can't seem to find an adapter that has a -8 male, and make end to fit into the stock 1g fuel filter anywhere.
Almost finished putting this car together, and have run into this final issue of the bottom support for my radiator is bent inward. Any ideas on how to unbend this?
I purchased a SS 02 housing from forced performance, i also have the 1g punishment racing fmic. Has anyone used this setup and run into fitment issues with the lower driver side intercooler pipe not being able to fit because of the housing's dump tube being in the way? If so how did you resolve...
Alright i got the first 3 screws off of the center parking light. Problem is there is no battery at this time to use put my lights up. Is this where the other screw is to take it off? I have never taken 1ga headlights/parking lights off before.
Has anyone installed, and used an apexi afc neo after being sent back to get re-flashed? I had already sent mine back to be re-flashed but i still hear storys of them messing up cars. Dont know if i should install it, or sell it and go with another afc?
Is there a difference between the non abs proportioning valve from a 90-91 and 92-94 awd dsm? found a nice delete kit and says the prop valve is from a 90-91, and i have a 92.
Im currently stationed in iraq, and on one of my previous missions i spotted a 1g dsm. Had no name tapes on it, but it was there right in front of me parked as i drove by couldnt have been more than 5 ft from it, who would of thought.
i have the walmart schoche radio wire harness for my 92 talon. i wired it all up today and everything went fine there was power and all speakers worked i even drove it for an hour with everything working.
i turned the car off for about an hour while wiring my amplifier and subwoofers and now...
so i went over the new shell the other day for what i thought was the last time. i noticed almost all of the driveshaft to diferential bolts and all of the 4 bolt axle bolts were missing. would it be alright to put regular bolts in or is there a certain number or strength bolt that i should be...
just finished everything up and now i can start the car up but wont stay started for longer than 5 seconds and the ecu continuesly ticks pretty loud..im using a 2g throttle body would that have anything to do with it?also there is three connectors i do not have connected and do not know...
im putting my 90 motor into a 92 my c.o.p. setup has the connector for a 90 harness and wont fit this 92 harness. i have the harness out of my 90 to swap connectors, but the 92 is a 3 wire, and the 90 is a 4 wire..
any suggestions? this is a very expensive coil set i dont want to have to just...
wiring my motor today it's a 92 talon, and noticed these two wires were cut. anyone know what they could be for? they are right before the 02 sensor connector.
ok it all started with my 90 gsx, over two years put pretty much all of my money and alot of my time into.
This summer due to a cracked rim that couldnt handle a turn at 75mph on the highway, i lost my 90 gsx, but with luck nothing under the hood was damaged except a slight indent...
So it's winter, it's cold, and i hate it. there is only two good things about winter, snowboarding, and parking lot drifting. all i can do is miss the things i like about summer, like cliff jumping for one. anyone else go cliff jumping? and for us unfortunate 'imo' to have the cold seasson what...
let me know what you think. got a real good price on it, mint condition interior, 3'' turboback exhaust, and still has the blown motor sitting in it. just needs a bumper and a little body work, has a few dents but will all get fixed at the body shop. anyone know the color code for a 92 teal...
i have a 90 transfer case, and a 92 talon without a transfer case.
can i use my 90 axles? will they fit on the 92 talons hub side so i can use the transfer case?
i just called apexi, because i've heard there are problems with the karmen sensor. but i've also heard that there is a certain serial number that this has been fixed. my serial number ends with 01271 anyone know if mine is alright? the guy said all i have to do is send it in and he will reflash...
my car seems to crawl forward when im redlining with the clutch all the way down ready to launch it. this has messed my time up at the track before by jumping the sensor. i have resulted in using the e-brake to keep my car still, but just wondering if this is a my car thing or is this with...
Are there color statistics for 1g eclipse and talons? as in what color in what year and how many of each color they made every year. i've tried researching and havent found anything out.
i had bought a rear motor mount bracket for my 2g 1996 eclipse gsx, but this doesnt match up on the tranny side.
does anyone know what this rear motor mount bracket is from? i know it's not from a 90 gsx thats about it.anyone? i know im bumping this but i kinda need to know?
this is a 96 gsx i bought the car as a shell put the motor in and there the plug right after the 4th injector plug is cut. there is two seperate both with three wires are red black and blue. here are some pictures
im putting a 14b turbo on a 2g automatic motor. i am missing the 2 coolant lines and 1 oil line. just qurious will the 1g coolant and oil lines fit properly on a 2g engine? pretty much asking if you can put a 14b on a 2g.
i have a 2g eclipse that im swapping a 7bolt into.the motor that i bought is an automatic. i have a problem with connecting the flywheel to the crank. the problem is that there is a circle peice in the middle the automatic peice that was on it fit, but does not fit with the standard flywheel...
will replacing a 2ga spoiler with the 2gb high rise spoiler leave an unpainted part or will it be staind in any way that would show after installing the high rise?
i am doing a 6 bolt swap from my 90 gsx to a 95 tsi. what will i have to do about the wiring harness. how would i go about wiring it correctly. and any other problems i might have doing this swap if anyone has any info would be helpfull.
punishment racing has a good deal on a fmic set going right now that im considering, i plan on looking for high 400 horsepower for my build just need some thought if this would be a good enough kit.