The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support STM Tuned

Search results for query: *

  • Users: poundcake
  • Content: Threads
  • Order by date
  1. Oil leaking from coolant inlet and outlet while priming

    I just got done putting my engine together out of my 1990 gsx, new gaskets and everything. So I go to prime up the oil lines with the drill method and about 10 seconds of drilling, I leaked almost 4 quarts of oil that came pouring out of my coolant inlet and outlet ports. The engine is out of...
  2. 6 bolt nt knock sensor question w/ pic

    I have been searching hard about this but I havnt come across a definite answer to my question. I just pulled a 6 bolt longblock from a 90 plymoth laser non turbo. The block has a hole where the knock sensor would go(i think) but it is sort of recessed. Numeruos people say all you have to do is...
  3. 95 Auto GSX Stalling When Stoped

    Hello everyone, I have a 95 GSX thats an auto and just recently had the transmission replaced. The car starts fine and idles fine in park and even if you put it in gear it will still stay idling fine until you tap the gas just a little bit and then the motor stalls out. I found a leak on the top...
  4. Is my 1g ECU done for?

    Ok, so yesterday I installed my new boost guage and checked for boost leaks. I got everything hooked up ok and went down the road for a test drive. After making a u-turn I stepped back on the gas, the cel came on, and noticed it running very rough than right before I made the u-turn. So i...
  5. 95 gsx auto from southern al

    Hey everyone, i drive a automatic 95 eclipse gsx for south alabama. Ive been registered on the site for a good while but never really posted. The gsx has been a small but really fun project. I got it last november and im currently looking for another one, perferably a 1st gen. The first time i...
  6. Emanage not tuning but is reading

    Hey everyone, as the title says i have installed and set up the emanage great, but i just cant tune with it. Right now i have only the injector harness hooked up and i can read airflow, injector duty cycle, and throttle position, but it will not do anything to the car whenever i try to change a...
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top