I searched, but i couldnt find anything, torque and pro are in way too many possibilitys to find what Iwant. Im gonna be running link v3 in my 97, I want to use m phone for logging. Mostly for fun. I want to know what people are doing for reading sensors and stuff.
I was given a scm6152e with a badly damaged turbine wheel. thats all that is wrong with it.I found a new t350 stage 5 shaft for it.Can i use a standard t3/t4 360thrust bearings and journal bearings from this kit...
I got a 92 awd auto with a bad tranny, started to hesitate when i pressed the gas pedal, now it barely will move till 4000rpms, with boost! Same in reverse.Im giving up on it, and I cant seem to find a 1g awd auto tranny.I can get a 90 or 91 fwd auto transmission and any stock parts off...
Ok my pop up heaadlights popped up while I was installing some gauges on the colum. I checked all the fuses and relays, I have high beams and low beams and everything else is normal but when I shut off the headlights the doors dont go down??????? Is it telling me something?
My 90 talon awd with 2g head swap alond with 93 sensors..starts but dies after a few secondsif I play with the throttle for a bit, it will eventually stay running enough to drive around and restart again.
Compression - good
boost leak test - good
leak down - goodI adjusted my TPS...
Can I swap a 2g IAC into a 90'?Mine is bad and all I got sitting around here is a couple 2g IAC's and a non turbo 1g IAC. They all seem to look the same and will connect into the same connector but they point in differant directions on the TB and are differant colours.Plus the 90 has a...
Allright My 90 6bolt tsi ran for 20minutes really well after a mild rebiuld, then I blew a coolent hose. So after I fixed the hose, I went to start it- and jumped the live fuel pump wire off the trunk floor. Since then it hasnt started.I get spark, fuel, and compression(well one cylinder is...
Are the rear calipers on a 1g the same for AWD and FWD?, Everywhere I look says not for AWD? I want used rebiuldable rear calipers but I cant find any AWD's around here.
I have a blue wire and a yellowish wire going to my OFH for the 2 oil pressure senders.. which one is which? I have the connectors but need to know where they go.ALSO the 2 wires going to the coolent temp sensor... black and brown, does it matter which prongs they go on?
I read in one post about someone modifying a regular 255lph walbro to make it a HP. I did some research and found very little info on this idea. Apparently you push the spring retainer down and it blocks off the pressure relief valve.Does anyone have anything else on this idea?, or tried it?
Any one using this regulator?, it seems a bit hard core, It has to run stock, with a wally 255lph for now untill I upgrade. Its a 13113 efi ultra high performance. I can get one cheap!
Can the 2g rear calipers and brakets if needed, fit in a 90 awd tsi? I have a 95 or 97 availablefor parts . I'm taking the fronts, but I need rears anyway, so will they work?
Can I check the input seal on my 90awd tranny, by placing 2 axle stubs into the axle holes and filling the tranny with fluid? Will the fluid leak out when the tranny is still sitting on the floor. I really dont want to rebiuld unless I have to.
I have the torques style head bolts on my 6bolt. I aquired the block in peices and the old head bolts were in a bag with no washers. I want to replace them but everywhere I look they only sell bolts without the washers. The 7 bolt smaller bolts have washers and I keep reading in the theads about...
I'm an idiot, I meant BURNT
I
was at the wreckers a couple days ago stripping a 92 talon( Canadians..there is a 6bolt in it!) It had burnt up in the rear pretty bad. ###### gas tank fire or something. anyway it has 17" really nice rims, with 2 yokas' on the front. problem is the back rims...
FUEL CONTROLLER AIRFLOW TRANSLATOR MAS MAFT AFC SAFC APEXI - BonanzleHey guys, has anyone tried this? I never seen it before and it just showed up on ebay so i did a little research. Looks like a maft thing. It has knock controll , and adjusts that airflow and o2 readings , and converts...
OK, Before any one says "just go buy a 90 OFH..." YA YA if it comes to that, then sure I will but thats not the answer I'm looking for.Before I go out and spent $30 plus on a 90 OFH, hear me out..Adding a external oil cooler to a 92 OFH:I took out 2 plugs and replaced them with hose...
Hi My name is Jason..I have a 90'awdtsi...I just finished pulling out the engine..and I could not get the passenger side drive shaft out so I dicided to push the tranny away from the block and just pull the block..Well it worked but I'm definatly taking the tranny out and there going...
I have the stock small hole at the top, and Ive been soakinng them in acetone for 2 days, now I'm trying to clean them like the vfaq, but I have questions I cant find in the search.Should the lifters be able to compress by hand without the paper clip?I have 5 that wont compress at...
Ok, I have a 1g tsi awd. I'm rebiulding it for th most part, head job right now.I just got laid off and with my spare time I just want to get the car on the road.(safteid and etested)I have a 255wally, afpr, and a hks safr, and fmic... And a holset hy-35!I know with that, I can run...
I have a ton of 3/8" stock, can I get away with making a t3 flange from that and run high boost from my hy35?, or should I invest in a 1/2" t3 flange?
I see tons of 3/8" flanges for sale.
Ok, I bought a non running 90 awd tsi for $500. This is what I got...Drive train seems still ok, everything rolls and the suspension looks new.I new the belt had skipped and the valves were bent, pistons were fine..according to 3 mechanics. But while I was cleaning it up, I found the...
Hey, I'm Stace. I have boosted my saturn, 5psi, intercooled, fabbed my own turbo mani, blew my engine up!!!Now I have stepped up, and aquired a 91 talon awd tsi, For next to nothin! But the belt slipped, or something and well you guys must know the rest!It gonna be my project car for...