So I recently purchased a new rywire harness for my 1g auto drag build I'm finishing up. It's the flying lead harness that has a 20pin connector that has 20 wires that need to be wired in to complete the install. It says on their website what the wires are for.I'm trying to find someone who...

So I'm planning a build over the winter for my 1992 awd auto talon. I have a g4cs block, and a .010 machined 6 bolt 4g64 crank. Was just curious if anyone has ran this combo before? Not looking for extreme power numbers. Will be running a gtx4088r turbo. What rods/pistons etc...fuEl will be fic...

So I'm planning a build over the winter for my 1992 awd auto talon. I have a g4cs block, and a .010 machined 6 bolt 4g64 crank. Was just curious if anyone has ran this combo before? Not looking for extreme power numbers. Will be running a gtx4088r turbo. What rods/pistons etc...fuEl will be fic...

I've used the search on here and dsmtalk and havent found the information im looking for yet. I got these cams in a head i bought a while back. They have the markings "HD", 211, and E. I cant find out if there aftermarket or factory. Please anyone with info please help me out. There also from a...

Over the last three weeks iv done a few mods to my auto Dsm. Including short route front mount, machv hard intake pipe, Evo 8 maf, fic 650cc injectors, Walbro 255 pump, 2g exhaust mani, tubular recirc o2 housing, and a EPROM manual ecu with key diver chip that's burned for the injectors, pump...

First off not really a noob. Been in the dsm game for 6 years now. But lately while driving on the highway my car has been shifting into o/d at higher rpm's and just free reving. I'll let off the gas and the car will down shift to third and eventually o/d and then drive again.If I drive the...

So Friday, 7/22/2011 I'm making the 4 hour drive home from alamosa where I'm currently working. I'm about 10 mins from home, in arvada, when I'm exiting from c470 onto i70 east. I'm going to put my car from 3rd to 4th gear and let the clutch out and clunk. The trany lost all power from the...

Hello my fellow dsm gurus. Im curious as to if a 23 spline 6 bolt tranny would fit my 95 tsi 7 bolt. My buddy has a tranny that has less than 3000 miles and has been done by jack of the springs lying around from his 91 tsi awd part out and i would like to buy it from him cause my stocker dived...

I own a 7 bolt, 95 maroon 2g that i plan on building the head and doing a jack tranny to over the winter. The head will consist of 280 cams, stainless valves, dual springs with titanium seats and retainers, new valve guides, new valve seals, new valve locks, with a sheet meatal intake mani. I'm...

I dont know why but my cars 16g actuator is making my car push 17psi+ at times. It holds true to 10/11psi until about 4800rpms then starts to creep up to 17/18 psi. I have no boost controller and i took the vacume lines off the stock bcs and just tied them together with a T. My friends have done...