I am looking for a measurement of the "snout" on an awd dsm 1g 5 speed transmission (91 and up) where the throwout bearing rides. The collar that is on the bell housing where the throwout bearing rides has a length that i would like to verify. Please, can anyone measure this and share it here...
Hello,
What map sensor are people using to run boost above the limit of a 5 bar AEM sensor? I see AEM offers a map sensor which goes to a higher level of positive pressure, but doesn't seem to be able to register vacuum. Please share what you are doing. Also, is the series 1 AEM box capable of...
For sale: Kiggly Beehive valve springs, seat locators and retainers. These are the "high pressure beehive springs" Kiggly sells, not the street springs and not the race only springs. They are used with less than 10k miles on them. They are still in good shape, I just went with brand new valve...
For sale: 1g DSM 6 bolt ARP L19 head stud set. These have been torqued probably 3 total times. I was going to reuse them in my build, but I decided to purchase a 100% new set. These do not look to be damaged and as per ARP should be re-usable and should not stretch.$200 OBO.
I have my FP Super99 turbo setup for sale. This is comprised of:
FP Super 99 turbo. Ball bearing, 72mm inducer compressor wheel (billet), .85 a/r T3 FP turbine housing.
Shearer fab t3 header.
Tial 44mm v band wastegate
DEI lava / C.F. header heat wrap
EBAY t3 Lava T3 turbine housing blanket...
For sale:
Pte 6766 dual ball bearing turbo: .82 ar t3 turbine housing.. Make offerBjs sheetmetal intake for 1g head. Drilled for mustang throttle body. This was originally on Sheps 1g. Has n20 bungs... Make offerTurbonetics t3 manifold with custom elbow for tial waste gate. ..make offer...
Hello,
I am planning on wiring up an additional set of injectors on my 92 awd dsm. I currently have a set of FIC 2150cc injectors in the car, but am running out of fuel at high boost. My plan is to likely run a set of 1100cc high impedence FIC injectors mounted to my magnus intake manifold using...
Hello,
I am trying to wire my autometer 4590 0023-12 fuel pressure gauge (autometer pro comp ultra lite) to my aem ems v1. I would like to be able to datalog my fuel pressure while under boost. According to the AEM EMS install instructions, I can use pin #74 (ADRC11- available 0-5v input). On...
Does anyone know when the new PTE 6870 is going to be available? Better yet, does anyone know how well it works? I have heard it should be as good or better than an fp super99. Wondering if perhaps there are some "Beta" testers out there somewhere?
Recently I was approached to design and build a waterpump pulley for a 2g. When relocating the alternator to the back of the block (6 bolt motor), the alternator pulley rubs the framerail. One solution is to smash the car with a hammer until it properly fits. Another solution is to use a pulley...
Hello,
I was wondering if anyone on here has the cam card for the fp11r exhaust cam that was once available thru Forced Performance. I have acquired one and would like some specs for degreeing purposes.Thanks!
Went to the local dragstrip saturday in my 92awd. Drove it there on my regular street tires/wheels. A friend of mine lent me a set of 16inch wheels with 26" hoosier QTP's. In full street trim(minus the normal wheel/tire setup) the slip went like this:60ft: 1.6095
330ft: 4.3825
et @ 594ft...