I have two turbo options this year for my local 1/8th mile track. i have a built 8:8:1 forged 6 bolt with BC 280's,and FIC 850 injectors and i just recently put this engine into a 1991 eclipse GSX automatic car with fresh rebuild on trans and stock converter. What my question is should i run my...

I currently have my hx super 40 t4 19 cm housing twin scroll with a custom made twin scroll t4 manifold with twin tial 44 mm waste gates and two dumps. I traded this whole setup to a buddy of mine for his 7 blade hx35 twin scroll 12 cm with a open t3 style tubular manifold with a single external...

I have a 1995 Gutted GSX engine is a forged 6 bolt 1g head bc 280's and bc valvetrain holset hx super 40 with 19cm exhaust housing been messing with launch control settings and what would be the best setup settings for both anti lag and two step to get me some good 60ft times? I currently have...

My 1998 GST has a black box style ecu and has a 1995 cam sensor (under the intake gear) was curious what exactly is the way the spark plug wires go from the engine to coil pack?

I have a 1998 GST. 140k miles nearly stock only mods done are injen intake and a cat delete with a megan racing catback exhaust. My problem is anything under light load and under 3k rpm the car hesitates(kinda like a miss but not) and under cruise control it hesitates very little. I have...

Exactly what the topic describes. I recently switched over to SD and the previous owner had already modified the SD VE table. I'd like to start from a fresh default SD VE table to tune with. I was hoping one of you guys could send me a link or a nice detailed picture of a non-touched SD table...

Just needing a go over on my pull log and some advice.adjustments to be made. I'm very upset that my buddy's small 16g car on 22 psi. is spanking my hx40 awd so i am in desperate need of a tuner's help with my poor tunning

my car is a forged 6bolt swapped 95 tsi awd with a 8 blade hx40 and bc 280 cams and valve train what should my airflowperrev and combined fuel trim with FIC 850's. For some reason i can't get my ISC to get to thirty and the isc motor is working properly.I'd like to get some tweeks and advice to...

I purchased a 97 eclipse gst with a 6 bolt swap i removed engine and put it in my 95 eagle talon awd. I am having difficulty getting it to idle to even start the tuning process the only way i can get it to idle is with the throttle adjustment screw tightened down quite a bit then i idle pretty...

Looking for Local ECMLink tuners V3 or V2 savy to help a few (new to link) noobs in the Cookeville,Nashville area.

My question is,i'm running a HX40 with 800cc injectors,a walbro 255 and a fuel pressure regulator what should i set my fuel pressure to?

as it says i have a 97 built gst with a 6 bolt swap coolant slowly builds up in cylinder number three inside my spark plug wires and is causing it to miss. i can drive about an hour after i clean the spark plug hole out and it no longer misses what could this be? no white smoke from exhaust. No...

i have a write up of taking a turbo off and replacing it with step ny step instructions going from turbo to N/A i've searched everywhere and there wasn't any wrote ups on it so i made one . just asking where and what place you would like this write up placed ty

i have a 1995 eagle talon tsi awd i was driving my car into town today when i heard two very light clunking noises i get to the parts store to buy a coolant temp. sensor and i smelt trans fluid so i looked under my car and gear oil was pouring off my transfer case could this be a seal or has...

i have two AWD cars both 1995's the car that will be swapped is my 95 tsi awd but its auto and my 1995 GSX donor car witch is manual both cars are complete but my auto trans has gone out so i'm wanting to swap my auto to manual. my question is can you use the manual trans and diff from my mt car...

Guys needing some input here on my spring build.i can't decide to do a forged 2.4 hyundai sonada engine build or a 2.3 stroker build. and if i go 2.3 stroker whats a good compression ration to go with i'll be daily driving and weekend warrioring the car. and i'll go with a big 16g or 20g if i go...

This is a 1999 Eclipse RS. It does not run right now. I believe it is a electrical issue. The starter will not turn when on the block, but it will engage and disengage. When not on the block, the starter will work. what do u guys suggest?

Ok guys i'm back again,and after hours of reading i want a few opinions from fellow dsmers.i'm debating on my next upgrade choice. do i either get a forced performance cold air intake,convert to a 2g MAF,or go with hardened intercooler piping? and before anyone asks i have all the free mods and...

ok guys here i am again with another hopefully good answer to my very scary question.I took my car to the track this weekend and run good times for a stock car she did a 9.24 @ 76 mph. well after i got home that night i notices very very faint ticking coming from the bottom end on the drivers...

Hello once again DSM community i have a stock 90 tsi awd with all the free mods done.I'm going to our local track this weekend to do some heads up races friday night.i'm currently running 15 psi on 93 octane and she is running sweet my question is if i get race fuel what could i safely turn my...

just as the title states. i replaced my CTS and is still hard to start,i replaced fuel pump/sock along with fuel filter under battery tray. car will start after about 30 seconds of key bumping,but will be hard to start also just after i turn it off. what could be causing this i have posted 2...

Hey guys me again. What i'm having trouble with is my car is hard to start (hot or cold) and i researched the forums and found that the CTS can cause this i'll probably be purchasing one today but was wanting to get a few answers before i did.1.)In most cases has the CTS replacement fixed...

Hey guys me again. What i'm having trouble with is my car is hard to start (hot or cold) and i researched the forums and found that the CTS can cause this i'll probably be purchasing one today but was wanting to get a few answers before i did.1.)In most cases has the CTS replacement fixed...

Well fellow tuners i took my stock tsi awd to a friends house that has been talking allot shit with his 2004 altima 3.5 swap CAI,Headers.All i have done to my tsi is the free mods so far and was running 14 psi with 93 octane.each time from a dig i tore him up but running from a roll he smashed...

i have a 2g head and intake on my 1990 talon tsi with a 1g 1990 tb on that 2g intake.Now my throttle body gasket is leaking underneath and i will need to replace it but what gasket will i need to make this work?The 1g or the 2g gasket?Also can i get an aluminum gasket and where?

Hello tuners, its me again,i have a few questions about my current setup.The reason i posted a new thread was my current combo of parts are very unique so i need specific answers.I'd like to start out with my combo for viewers to better understand my questions.I have a 1990 eagle talon TSI AWD...

ok guys got a 1g 1990 tsi awd decided to do a boost leak test results were..... gauge read 2psi max.and u could hear a pretty good bubbleing coming from the oil cap is this common or is it a bad ring issue and requires a rebuilt to solve ty guys :confused:

k guys my application is very specific so thats why i post almost every problem lol so i now have my car running 2g head and intake on a 1990 eagle talon tsi awd.i'm running my original 1g 60 mm TB on this 2g intake and i seem to have a horrible leak around the gasket that mates the TB to the...

k guys just finished up my 1990 talon tsi awd did a 2g head and intake swap and retiming kid installed. what my problem is the car will start and run but will not rev over 3k rpm just installed a new fuel pump and screen,also blew the fuel line out to get old gas out and drained the old gas out...

k guys here is he update i got NGK plugs gaped them to 28 and i verified i have spark to all my plugs.I have fuel to the rail,and also tried to turn the CAS 180 and still not even a sputter.So i had my daughter turn the engine over while i listened to the injectors for clicking with a 1/4 in...

k guys i'm done with my build what i got is a 2g head and intake on my 1990 talon tsi 6bolt block i also think i messed something up i had the 2g and 1g coil packs.what i did was i took my 1g coil pack off the 1g bracket and bolted it to the 2g bracket so it will fit under the 2g intake in its...

k guys got a 1990 tsi that had a bad head so i replaced it and timing belt,it was also setting a few years like 2 years.i have spark but my fuel pump isn't coming on i also undid my fuel line to my fuel rail and tried to start the motor to see if any fuel is coming out and nothing i also drained...

k guys i just installed my 2g head on my 90 tsi put on my 1g tb and started to install the throttle cable and it won't fit any mos i need to do or am i just doing something wrong btw i am also running the 2g intake mani as well ty guys:confused:

k guys i got a 1990 tsi with a bad head and piston just ordered a 2 g rebuild kit(2g pistons on 1g rods hope works out well) my question is can i just swap over my 2g head and intake after i port the oil mod #1 and bore the head bolts out with a 1/2 inch. bit will my CAS and fuel rail bolt right...

i have a 1990 tsi awd bought it with a bad head(timing belt broke bent valves) i have a 2g turbo head intake and tb was wanting to know if i can use my 1g intake and tb on my 2g head or do i have to use the 2g manifold and tb on my 1g? ty guys for all the help