The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support Morrison Fabrication

Search results for query: *

  • Users: Loewen21
  • Content: Threads
  • Order by date
  1. Shot Wideband Sensor?

    Hey guys so i installed my DynoJet wideband a little while ago and ever since install it has given my weird readings. It will read fine on anything from 14-18 at cruise and idle and such but any time it seems it should be reading between 10-14 it will just stop at fourteen. But it seems at times...
  2. Car starts, revs and dies

    Ok i know there are several other threads about this as i searched, but none of them are quite the same. Like stated when i start the car it will start and rev to about 3000 then slowly rev down and die. When checking the voltage the injectors are getting it seems to be constant?? and from my...
  3. 1G Car Wont Start Once Warm and Won't Boost

    Hey guys so been having problems with my car lately. It will start fine when it's cold and drive fine except that once i get into boost there seems to be stuttering of some sort and no power whatsoever. Also, once i turn the car off it wont start again while it is warm but once it cools off it...
  4. Sutters under boost

    Hey guys. So i cant figure out my problem. have it narrowed down and just wondering if my thoughts here make sense. Ever since my car died on me one day i've been having bad problems. I replaced my ecu and isc which were both fried. Now, my car refuses to boost properly. idling, driving out of...
  5. 1G Different axle seals?

    Hey guys,Just wondering if the seal between axle and transmission is different between the drivers side and passenger side. The guy at NAPA told me they're different but i thought they were the same? Can anyone confirm whether they're different or the same? I bought one because i thought my...
  6. MAP with Link?

    Hey guys just looking into dsm link, im running an hks vpc/gcc setup right now. Wondering if i can run my MAP sensor with dsm link?
  7. Bad TPS causing hard starts?

    Hey guys quick question for ya,I saw the other day that the wires in my tps connector were pulled out OMG By this i mean the 3 wires that go into the harness that connects to the sensor itself. No idea how it happened, but nontheless it happened. Ever since this happened it seems my car...
  8. Car runs fine for a minute and then sputters

    Hey guys so i've been having alot of problems lately with my 92 laser. First of all, when day when i went out to start it it simply wouldn't start, but with the isc unplugged it started and ran good for about a minute, then after that minute it started to bog and sputter until it died. Now...
  9. Not starting with isc plugged in??

    Ok so here's whats going on. First of all, i had a shot knock sensor that i need to replace. So i go to start my car one day to go to work, and it was warm since coming home from school still (still in high school unfortunately, only 17) and it wont start?? so i open the engine this bay and...
  10. Repeated frying of ecus

    Ok so on my friends 92 eagle talon we just installed a new clutch. After this was done we went to start the car only to find that it was running on two cylinders. So we checked and it was getting fuel ok good, but no spark. So we changed the coil, spark plugs and wires only to still have no...
  11. Basic VPC Tuning Knowledge Needed

    Hey guys, so my car came with a vpc and gcc combo already installed. So i'm wondering basically what everything does exactly in regards to the response, gain, and output knobs on the VPC. The idle is pretty self explanatory but if anyone could tell me exactly what these adjust to help me tune...
  12. Wrong axle, what's wrong??

    Hey guys so i just ordered a new front passenger side cv axle for my car. So i take the old one out and go to put the nice new one in only to find that it doesnt fit!!! The shaft that slides into the transmission is a bit bigger than the old one. Im wondering what they could have sent me. If...
  13. Starting Trouble, Exhaust Leak?

    Hey guys so i just installed my evo 3 16g and during that i found out i had two stripped stud holes on my head so without a helicoil to get that fixed right away i just slapped the exhuast manifold and turbo back on, being wayyyy too excited about the new turbo. So needless to say now i have a...
  14. Fwd axle in Awd

    Hey guys just wondering if an axle from a 91 fwd talon will work in my awd 92 laser. Pretty much the only option i have to go with right now so if it might take a little bit of time and effort to make it work im fine with that. Thanks in advance.
  15. Crazy boost creep with external gate

    Hey guys just installed my evo 16g today and now im getting insane boost creep. I know its not the boost controller because i checked by running the line to the wastegate just from the j-pipe without the boost controller and got the same effect. Im running a tial 38mm right now mounted on the...
  16. Installing coilovers, what else to replace?

    Hey guys i just ordered myself a set of D2 coilovers which im pretty excited about :cool: Just wondering what other bushings and such i should go and replace while im at it
  17. Alternator causing surge?

    Hey guys, well i did a search and couldn't come up with a straight answer so i'll just start a new thread. I was wondering if a bad alternator or one that was on its' way out could cause your car to idle surge. With my accessories on (lights, defrost, etc.) the car will surge but with them off...
  18. Fuel Management Problem/Question

    Ok guys i know this may sound like a stupid question but here it goes. So i bought my laser in July of 06, and it had everything done to it listed in the profile, i have done nearly nothing besides change a couple sensors and some minor stuff.It came with an HKS VPC along with the GCC and i...
  19. Creeping tial 40, unexplainable

    So here's the situation: I run a stock 14b with the fuel works done at 20 psi using a greddy profec type B. my tial 40 mm gate is off the manifold. once i start hitting higher rpms (5000 or so) it begins to creep, even though you can hear that the gate is open. i've experimented with the...
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top