Plugs have been replaced. I spray maf cleaner on rag and wiped it very easy. It did throw code in the beginning cylinder 1 misfire fuel injector issue.
Alright. My 99 has sat for a few years. I decided to hold on to it. No gas was in tank I am assuming it sucked out at some people. I put about 5 gallons in with seafoam. I even cleaned the MAF. I ease on the gas pedal and get stumbling. It cuts off. Now, after letting it run for awhile it...
I have been finding it hard to find a new/used coolant tank for my car. It leaks right around the seem on the back side. If anyone can point me in the right direction that would be great.
Do you have a CEL? If not I would check the vaccum lines especially if it is stalling out and the rpms drop really low. The fuel filter would cause missing during acclerations. MOST of the time fuel filters will outlast the car unless you putting crappy gas in the car. I would plug all plugs and...
Check all your fuses and replays and if that checks you there may be an ecu problem. From the sound if it sounds like a crossed or bad wire to cam sensor.
It sounds like your alarm system may be wired to the wrong wire especially after you said that when you unlock the car and they flash bright. I would take it back to who ever installed the arm system.
I have a question about gauges. Are the readings different on a 420a cluster then a 4g64 gauge? My concern is that temp gauge goes pretty high before the fans kick on. I use a scan tool and it shows the fans kick on around 208 degrees. Is that the temp they are suppose to kick on? I also...
I drained all the fluid out but I really wanted to drain the torque converter as well to get all that old fluid out. I replaced the filter and gasket as well. The shifting has improved a lot but the thing I was really pissed about is the fact I had Mitsubishi do all that a little over a year...
I have a strange issue with my tranny fluid level. When it is cold the fluid is reading at the hot level. When it is hot it reads the same. I don't understand it at all. I aleady have shift problems as it is. I would like to know has anyone else had this issue with their fluid levels?
It came with them up front just not in the rear. The right rear wheel cylinder was leaking better bad as well and it ruined the inside of my rim. The fittings I messed up were the steel pipe to rubber hose fitting and and the steel pipe line that runs from the wheel cylinder to the rubbe hose. I...
I finally got the nerve to do the drums to disc conversation and I most say the hardest part of it all was trying NOT to screw-up the fittings. I screwed up the fittings on both sides and was disgusted with myself. I finally figured out a way to fix them and I think I did pretty well with it...
Okay and was that the bottom fuel line on the fuel filter? The one I have to replace is the bottom fuel line. Well, thanks for letting me about that. I still am going to take it to the dealer because I have nasty oil leak in the timing belt area.
During the replacement of my fuel filter. The fuel at the bottom of the filter was broken during the process of the filter removal. The question is does anyone know for a fact if you have to drop the fuel tank the replace the line? Please let me asap because I am going today to order the line...
Hey guys I am about to do a new makeover on my Sypder. Would you guess suggest anything for me to do. I am getting it repainted (finally) I had to save some extra bucks for it because this guy backed into my car sitting in front of my house and took off on me. I would like to do the rear brakes...
Okay my fellow DSMers...I am sick of the 40-80 dollar HID kits off EBAY and would like to know which kit is better. These kits are both made in Germany Mtec and Phillips out of these two which is the best. I do plan on buying a set for ALL three of my vechiles. Some input would help or...
Alright, well I guess I will go to a salvage tomorrow and get one that works. Before anyone asks why, I am letting the car sit 5 days out of the week. I am getting a lot of things fixed on it starting with the most important to the least important. So I see no need in having an aftermarket radio...
Okay, today I put my stock radio in. I hear the cd playing and the sound is low and it don't matter if I keep cranking the volume it will not turn up at all. Does this mean the radio is bad??? Or is the Amp bad??? Prior to me reinstalling the stock radio I had Alpine head unit and that plug and...
I have the viper 5901 already. The shop that put on the 5901 is going to charge another 350.00 to put on the Smartstart then on top of that I have to pay 100.00 for the yearly cost (3years).
I have a custom made AEM intake as well. I just wanted something that was made for the 2.4 you know. I like the Weapon-R intake. Now say that AEM is better but from what I have read is that foam filter had better flow and cotton filters didn't. It also said that it also let's me dirt into your...
Thanks I am going to go look in the salvage yard today and just get another seat. I am sure it's not that hard to take your cushions off and put them on the other frame. Mitsubishi wanted over 500.00 just for the part the shop told me I needed.Well, it was two things wrong with my seat the...
Okay this morning I slighlty stood up in the seat to get my wallet out of my back pocket and all of sudden the seat just snaps back. After, that the seat will not come back forward or anything. My question is it fixable at home or do I have to take it to a shop? It's a Sypder and the seat is manual.
Don't worry about now guys...I found one. The problem I ran into was because of the cruise control no one had that instock but I went to a salvage yard and just got the cable the runs thru the fire wall. Sorry about ALL the confusing and the grammar errors that have seem to be more important...
Wow...seriously like I do NOT know about the grammar rules of the site!!!! I just asked about the throttle cable NOT a lesson on gammar but thinks for ALL non-help guys!!!!I may NOT asking for a spoon guy!!!! Just help and if that's a spoon so be it!! Thanks a lot for the rudes....ALL the...
Okay....about the grammer!!!! I was in a hurry big deal are you an English teacher or something??? I didn't know we had those on DSMtuners!!! Well, that's enough of that. I do however have a question about who sells them. Does autozone, advance auto parts, and or O'Reily's auto parts sell it. I...
Okay this just started...I put my car in reserve to leave and went to hit the gas padel and nothing happen so I pushed it really hard and the padel when it and idle really high to the red line. I notced that the plastic surround the wire itself comes throught the firewall when I press the pedal...
Okay pulled the carfax on it as well. I noted airbags deployed some frame damage. It also noted it was inspected twice by Texas DOD if anyone knows about the dealership in Dallas called Autonet please let me know about their rep. Thanks for all the info.
Alright I found out why it had a salvage title at first is because it was wrecked on the front right side. They sells person said it drives fine without any issues...but still my whole thing is that it's listed for 5400 with 73,000 miles and they haven't sold it yet. My insurance company told me...
Okay guys I have a very important question. I am getting another car but still keepin my DSM just going to fix everything that's going wrong with it. The car I am looking at buying has a "rebuilt title" has any on here purchased an auto with one of these titles and how hard was it to get full...
I know the ticking sound is the lifters but I am talking about the grinding sound. The thing is when it's really cold out it makes that sound as I have noticed but when it's warm out I don't hear it.
It didn't go away at all..but today after driving it it went all and on top of that it's warmer outside today too. I knew it seemed like a barring but I can't pinpoint where it's come from. To me it sounds like the idler because it seems to be in that area. The timing belt was change at like...
Okay I took of the top part of my timing belt cover and seen this...oil leak directly underneath the cam gear. I am wondering if it is leaking from just this area will it cause oil to be everywhere inside the timingbelt cover? Here is issue number two the sound it's coming from the on the...
You know I really thought about if that was it...I will check tomorrow. Okay I went and check the belts but the is coming from the timing belt area and it sounds like it's coming from the cam gear is at.http://www.youtube.com/watch?v=8fk9BPTx4JY here's a video so maybe someone can help.
Okay I noticed this sounding come from the driver side of the car. The sound stays the same at idle and at accelaration. It sounds as if it could be coming from the time belt cover or back on the engine. It's almost the side of barrings going bad. I also know I have an oil leak in the same area...
I got a Q what bulb size is the little tiny bulbs that are in Hazards, fog lamps, cruise control, mirror, and rear-defoger switch??? Can I get these bulbs off ebay in???
Here is my opinion on the retro thing. Okay I have a set of projector headlights made for my 2Gb. I put 5000k bulbs in them and they look awesome. I had 8000k's in them for like two years. Anywho I think if you want to retro use 5000k bulbs better light output and if you buy projectors for your...
I want a viper on her truck but 800 plus dollars is crazy. I only paid like 600 for mine and also added a radar sensor and a trunk pop all for like 60 and it still will cost me less than her's. I don't anything about AutoPage. That's what I need to find out about.
I have a question about AutoPage alarms. If any has a newer autopage two way remote let me how it works for you. My GF needs an alarm on her truck and I wanted to get her a Viper 5901 but with the module and alarm cost I would be paying like 800-1000 on it. Today I went to an AutoPage dealer and...