I just installed this electic unit today.http://store.summitracing.com/partdetail.asp?autofilter=1&part=ATM%2D4327&N=700+0&autoview=skuMy results with the car fully warmed up were:25 psi stopped in gear50 psi crusing at around 2000 rpm75 - 100 psi under full throttleDoes...

The manifold will will work, you just need the plumbing, ie. the oil and coolant lines from the 14b. Use new crush washers, this is a must.

My 3" from them is a slip fit.

No, it was a rebuilt 14b with a bullseye housing. I have a 1g auto so I was going to do a small upgrade since I don't have all the stage 1 mods yet.

That's what I was thinking but what I can tell you is that I squirted oil in the feed line before I started it. Also after it stopped working, when I took the intake off there was oil inside the inlet. I don't know my oil pressue because I still have the stock gauge but after it warms up it...

Just letting everyone know what I ended up finding out and to say thanks for the help.The turbo was bad, it didn't last more than a few hours. I sent it back to the place I bought it (g-pop shop - they were on e-bay and had 100%) and they rebuilt it and sent it back in a timely manner...

I was tempted to buy this kit for the price http://cgi.ebay.com/ebaymotors/DSM-FUEL-PUMP-REWIRE-KIT-Eclipse-Talon-Walbro-Turbo-255_W0QQcmdZViewItemQQcategoryZ42604QQitemZ8030620723QQrdZ1QQsspagenameZWDVWAnyone buy this one?

I took my air gun and blew a little air into the actuator and the arm moves out and sucks itself back smothly but I guess I need to take off the o2 elbow to see if it is closing all the way.I am also going to double check the compression test but you would think if I had that bad of leak by...

My 1991 TSI lost all boost from the last time I ran the car (it ran fine until I turned it off) and then a few days later I started the car took off and the boost gauge didn't move. The car runs fine just no boost at all. I did take my compressor air gun and spray some tree leaves from the...

Still haven't fixed this problem. I don't have any more info on the electical system to figure out how they work exactly. Once again I checked the 30 amp dedicated fuse under the hood, the 10 amp fuse under the dash and visually checked the grounding points by removing the lower panels in the...

On my 91 the automatic seatbelts never worked since I purchased the car. The driver side is in the open position and the passenger side is back.I checked the fuse under the dash and was guessing the one with the high beams/ icon with the seatbelt symbol but my high beams work. I checked...