Went to the IFO New England race. Was #1 qualifier in FIS then got kicked out after winning my first round for no cage. It's a solid second outing with my new setup. Legit street car that weighs 2985 with me. No nitrous. Best 6Oft was a 1.38 but blew off the IC pipe at the turbo. 9.65 pass was a...

Drove over 200 miles to and from the track today(total street car). HOT muggy day here in the NE. Right off the street at all of 29 psi touching 30 briefly according to the log..clicked off a 10.7@126. Promptly got the boot but was able to make another 1/8 mile pass that would of been a 10.6 for...

Great writeup on this here http://www.dsmtuners.com/forums/articles-drivetrain/286205-diy-1g-clutchless-manual-mod.htmlbut can find what wires to use on my 92 3 plug TCU? looked everywhereAppreciate any help!

:ohdamn: Was doing a hard launch off the 2 step and it lit up the cold tires and then it popped out of gear. Now when I boost in the lower gears it just revs like a bad clutch but in the higher gears it seems to hold the power. It goes into gear fine and from a dead stop it doesnt seem like the...

I feel like a newbie since I cant figure out why my hardwire to my fuel pump keeps blowing and my car wont start. I was driving along and it just died. Checked my fuse to the fuel pump (hardwire line) and it was blown, replaced it and it just blows over and over.Replaced the hardwire...

when your turn the piston clockwise to install new pads, what if they dont budge?! Can later year calipers be used if i need to replace?? Thanks in advance

mpi fuse is at the battery, but where is the relay....my injectors arent pulsing. thanks

I need some seriuos input for my 1G paxton race pump install. See how the pump is higher than the fuel level , even if i have a 1/3 tank its still to high? i have run it this way to 140 mph....but it was lean a little....can this be the cause? I think the pump pushes fuel and doesnt suck it from...

I have searched to no avail.....will the shifter cables or linkages have to be swapped as well? i know the t-case will have to be a 90....thanks for any input.