I've got this Precision exhaust housing found in my parts stash. I tried emailing Precision but they never returned my email.Hoping to build a new turbo for my 4g63T swapped Rx7.

Has anyone bought and used one of these cylinder head?http://sdparts.com/i-24078417-atk-2228e-engine-cylinder-head-for-mitsu-4g63-turbo-head.html

Has anyone order from this site? I stumbled accross them searching for NPR Pistons.http://www.onpfj.com/

So I bought a engine off Craislist that I was told came out of a running car. Since I don't trust anyone, I started tearing in partially down to check the bearing etc. Everything looked pretty good, little bit of junk in the bearing but nothing bad. I was told it had Kelford cams so I...

I need the Mitsu part number for the seal plate oring.For that matter if anyone has the parts list for 16g rebuild kit part, I wouldn't mind having it. The CAP software doesn't show any of the turbo internal part numbers.

When comparing different gears set in my spare transmissions, there are some 4th gears with 2 hash marks on them and some with 3. I always assumed there was a pitch difference and have replaced like marked gears.However, is there a difference? Is there a code to certain yrs have...

I'm in the process of swapping an upgraded trans in for my fragged one. I swapped the old shift fork and ball from my old trans to the new one. Including the shim I was using on the ball that was necessary because my master cylinder rod was adjusted almost all the way out. See the attched...

Has anybody used the output from a AEM 6-in-1 Gauge-Type Wideband UEGO Controller to log through the Pocketlogger. Any compatability issues? Will the offset function take care of any value differances?Just looking for info before I make the purchase.Thanks

Mine's leaking pretty bad, anybody got any recommendations or hints on replacing it.I've got the Haynes book, but the instructions on "using an inch-pound torgue wrench to see how much torque is required to turn the shaft within the range of gear backlash" "This is the drive pinion...

Ok, my dome lights don't work at all, but the floor and ignition light work when the door open. They also power down after 6 seconds. I removed the dome light and put 12v to the contacts and the lights work. I checked the plug in the headliner with the doors open and got no voltage. So...

Looking for recommendations for a set of all season tires for my 92 AWD. Was looking at Yokohama Avid V4s and Kumho ASX in 225/50/r16. Anybody got any experience with these tires? Want a decent performance tire for the summer and not get killed in the IL winter!

I need to replace the output shaft on my 5 speed transmission. I lost a bearing in the transfer case and it twisted the shaft splines. Can the trans output shaft be replaced with the trans in the car??? Pulling the trans in the driveway in winter does not sound like fun!

I guess since I'm a newbie so this belongs here. Just bought a basically stock 92 Talon last month...lost the trasfer case bearing and seal on the transmission side. The bearing race shredded and seized to the shaft. I got a got a used shaft and got the transfer case back together. Problem is...