IF someone knows anyone around the Des moines Iowa area that might be able to help me with my problem, could you let me know. I have no spark i have ran numerous test and cant figure out the problem.

I check the spark pugs and grounded them and no spark. Check the resistance between the coil pack. what else can i do.

I need to know where the location of the Ignition Switch Harness is? i got a 95 eclipse

I am having problems hooking up my EGT. The wiring is messed up for me. I got 4 wires. red meand constand power. orange is power when car is on. White is a light and black is ground. I got a 1995 eclispe, if someone can tell me where to hook these wires up to that would be great

my Front axle is stuck in the hub and i cant pound it out. i broke a CV boot and need to replace it. there are 4 bolts holding on the hub right by the boot and know way to get to them, with the boot there. i am open to any suggestions on what i should to to fix theis problem.

I need your help with this guys. I bought a JDM enigne it si an evo 3 motor. I am putting it in my car and under the water piping there is a place to connect a hose. I dotn know what goes there. I was wondering if anyone else has one or knows what to do. Thanks

This is the problem, i forgot to label where my hook ups went. Like the oil lines and antifreeze lines. If you can help me out that would be great. If you know a site or something with a picture. Or if someone can take a picture for me of there engine and where the hoses hook up that would be...

Does anyone know of a site that i can get to or tell me which lines go where. EX on the oil filter ass. there is two lines going out i forgot where those go. and for the turbo. just little things. i took out the enigne awhile ago and i forgot where these things go.

Here is the thing. i just recentley am taking my car back to stock. I have 95 eclispe GST with a 6-bolt engine. I put everything in like the chiltons said and to the right torque specs too. I put the block together and the crank wont spin. I dont knwo what can be stopping it from turning. I tore...

I need your help guys. I just recently found out that my rod bearings are going out of this engine that i bought online and i drove it home from the mech. and the blow off wont go off and it doesn't sound like the turbo is spooling up. vaccum is sitting at 10 on idle. It burning a little oil...

I have a problem with my car and i need your guys help. That car want gain psi. it wont go period. it puts along. i have had people tell me it is off a tooth on the timing. i checked and it wasn't, but could it be off on the bottom end i didn't check that. i ned your help

I have a problem. I just put my engine in my 1995 mit eclipse GST. I dropped a 6-bolt in. i took it out for a drive and the car wont get get pressure. i looked at my gauge and it was chillen an 10 while idleing. I did a boost leak test and found out there was a massive leak around the blov. If i...

I just recently put my new engine in my 1995 mit elcipse GST, 6 bolt motor. I am havign problems with a couple of things.. First one is that i got a vacum leak somewhere.. on my boost gauge is reading 12. When i take the car out i cant build up boost. the car just puts along. Second i got a...

I was woundering if anyone makes a traction bar for eclipses? I have bad wheel hop and i need to get rid of it. I would like some help if you guys can!