i didnt check to see if all four wheels can turn but as i stated before i was on the highway in 5th gear and tried to down shift and went into gears but no response from the tranny at all. Pulled the tranny and had it checked by a trans builder and found nothing wrong with the trans. i can put...
i have a 96 a 96 talon and the trans went out one day on the highway and never went back in to gear. I to the trans out and got it built but i can hear it going into gear but it wont move in any gears i also disconnected the clutch wire and i can start the car in gear and it wont even budge can...
i had the same issue with my 2g with a fidinzza fly so i just put my stock fly back in and the issue is no longer there the fly may have been off for sometime now
i had the motor in a fwd car and then i pulled the motor and put it in a awd car and i didnt swap the starter plate on the motor but i have been having grinding issues but i fixed the issue i drop the trans and changed the plate,flywheel and starter and the issue is fixed
i have a 95 awd with a 6 bolt motor in it i had the motor on a fwd before i went awd i swapped the trans and i didnt swap the starter plate so i pulled the trans the other day and put a 6bolt starter plate on and the starter seems to not catch or if it does it makes a clanking sound but the car...
i have a 95 tsi awd and i use to have the motor in a fwd car and i been having a problem with the starter grinding so i cut the hole bigger so it would line up on the starter for the awd and maybe like once a week i have to rotate it so it wont make a very loud grinding noise or it just wont...
95 awd talon i have replaced both sending units and the gas gauge will not go up more then 1/4 tank and i even took out the sending unit and moved the lever all the way up and it barley moves can some one please help can i buy a after market fuel gauge or something
i have a 95 tsi awd and i recently pulled the car down due to a leak in the smim and a bad drive side hub to make a long story short i put everything back together and the clutch grabs a little bit and the car will rev high when i hit the gas the tranny is in mint condition i changed the...
i got the flywheel from extremepsi and i looked at the part number and it was an awd starter i think the starter and the flywheel are not matching up very well i have tried new starters and some result do u think i need to space the starter with some washers?
i have searched but i have found nothing i have installed a fidanzza lightweight 6bolt flywheel and everytimg i start the car i get a horrible grinding noise i tried to space it with 2 wacshers but it didnt make it any better i have tried differant starters and i have pulled the tranny a couple...
i got a 95 tsi awd and just swapped the motor from my fwd to the awd and i got a awd tranny from some kid in ny and i am having major issues with it.
when u first move off the clutch grabs the after reving like to 3k rpms i hear a thump and then the cars basically free revs i have to rev the...
i bought a 95 awd tsi and the hazards,cluster,turn signals and reaf def has no power at all. the head lights and brake light work i checked the fuse and i switched the signal relay and some thing can come one help me i can get this this on the road with out these things working thanks in advance
i have a 96 talon and it has mods to long to list right now but i am having an issue that i cant find and it is slowly killing me. the 20 amp engine fuse keeps blowing. i replaced the alt already and it is gettin the correct charge. everytime i try to move the car the fuse blows or the car just...
i started then and know every time i move the car the engine fuse blows every time i did find that 2 wires from the o2 harness was out of the harness and 1 was touching the body of the car could that be the cause. i also took out my avcr cause i think that had part to do with it. the only mods i...
thanks i checked that i got the car up the hill last night and i was going up the hill the check engine light flashed and the fuse blew. i dont know what else to llok for it has me stumped.
my problem started last sunday when i hit a corner a 45mph to see how the tein ss would hold and ever since then i cant figure out what the hell happen. my 20 amp engine fuse blew then my alt went but that i knew was on the way out i changed the alt and now everytime i try to drive the car the...
i have a 96 talon fwd turbo and i notice when i am on the highway i hear a type of grinding noise but when i turn the wheel to the right the noise goes away i was told it was the wheel nearing could it be the passenger side or driver. I tried to put it on the lift but i cant detect anything.
thanks i put a new driver side wheel bearing hub on my car not even a year ago but i checked both side and i didnt have no play in it. i do notice if i turn the steering all the way to the right i get a clunk noise could that be the steering rack?
my dad has a 96 eclipse rs n/t and the wipers wont turn off they keep on going could it be a bad relay and if so can somone tell me where it is located?
i have a 96 talon and i have 2 issues.
1 problem is that when the car is parked and i turn the the wheel i hear like a clunking noise.
#2 problem is that when i am driving i hear like some type in humming noise i check the wheel bearing but the tired didnt move could it be a bad ball joint...
ok here we go again my car is doing the overheating thing again.
i have changed the radiator and all the hoses but it will push the coolant to the over flow bottle after 2 hours of driving. If i let the car cool down it will pull the coolant back in.
i did check for mixture and there is...
Thank you guys all for your help and support. I put a new thermostat in the car and re-torqued the head and put coolant in the over flow and everything seems to be ok i will drive it and keep you guys posted
It was fine when i was driving fot the 1st 15 min then it started to go up and down and is pushing coolant to the over flow very slowly and when i shut the car off it sucks it back in. Should i put a new stat in the bleed the system or what else can i do. people say it might be the headgasket...
I have a 96 talon with a 6bolt swap the car was overheating because of a hose so i changed the hoes and still have the issue. I have pulled the thermostat and it didnt help so i changed the radiator and the problem is not as bad as it was. I did a compression test got even #'s across the board...
well from what i was told it will only go up to stock boost if the lines are not right. i have the avcr on my talon and the same lines that goes from the intake to the bov u need to tee into that and put it to the side of the boost pressure valve and the from port on the valve go directly to the...
oh ok thanks for the replys but from what i was told i should use the same line that goes to the bov and put that on the side nipple of the boost controller unit.the line that goes to the wastegate will go from the front of the boost controller unit and it will run to the the side opf the...
i have just purchased a apexu avcr electrical boost controller and i would like to know there is a t type of sensor what vaccum lines goes where and what runs to the to the wastegate
i changed the cap with a greddy cap that is like 1.3 bar and i filled the system up and i let the air bubbles out and i took it out for a drive and the needle was in the middle then it raised a bit then the fan came on an it went back down. i took it out on the freeway and when i got home i...
i changed the thermostat like a week ago and put on a relief pressure cap on it but i notice that everytime i step on the gas the needle goes down then it will go back up. i changed the oil and the rad fluid and dont see any sort of mixtures i just replaced all the hoses caould the headgasket be...
i have a 96 talon with a 6bolt swap in it.
about a month ago i was street tuning the car and the upper radiator hose busted so i had to drive like 10 minutes to get to my house to change it and ever since then the car has been over heating on me. i changed all the hoses and i noticed that it...
i have a 96 talon with a 6bolt swap in it.
about a month ago i was street tuning the car and the upper radiator hose busted so i had to drive like 10 mins to get to my house to change it and ever since then the car has been over heating on me. i changed all the hoses and i noticed that it will...
i have a 44mm tial external wastegate with a apexi avcr electronic boost controller and i cant seem to run anything higher then 14 psi i need to know how do u hook up the vacumm lines for the turbo setup can some one help me
i have a 2g with a 6 bolt motor in it and i have the SCM-6152E (ONE BAD TURBO with a stage 5 turbine wheel) with a 38mm external wastegate on it and i can hit 6k and the car wont hit boost does any 1 know what i can do or what vacum lines need to be connected to make boost. is any 1 from the...
i pulled the head and i noticed that the valves look bent but i know that the rocker arms were moving so i will replace all of them and get it over with. thanks to all that replied to my thread
i started the car and i didnt get any knocking noise from the head but the car idles very choppy and i have to keep my foot on the gas to keep it running but i think it has something to do with dsm link to any other suggestions
i checked this morning and it did jump timing but the ss valves are fine so i chenged the belt and i line the timing back up and it wants to start but it wont fire up any suggestions i have pics of the timing right now i can email it to you. i need help asap
i have a 96 talon with a 6boly motor in it that was fully built and i been having problems with it but today i started the car and i herad a funy noise then i took it for a spin and i was getting knock very easy so i parked it. about 1 hour later i went up the street and i shut it down for 10...
i intstalled a auto meter oil gauge and when i try to prime the motor nothing is going to the head or through the plastic tube. this is killing me if anybody have ever been through this please help
i have a 96 talon with a 6bolt motor in it fully built but i primed the oil pump before the timing went on but now the motor is in the car and all the belts are on i am getting no oil pressure in the car at all please help!!