i am going to use ONLY the Innovate LC-1 O2 Sensor and remove the stock one. Does anyone know how to wire this? i seached around but couldn't find anything... i am sure it is out there somewhere. Some direction would be greatly appreciated.

Can you hook up the Apexi Auto Timer to the output signal on a Innovate LC-1? Instead of hooking it up to the narrow band signal at the ecu, can you use a the wideband signal from the LC-1 to get a more accurate reading to tune from...

can any one tell me the correct thread size/pitch for running your oil feed from the filter housing. i have an air cooled filter housing.thanks,

I installed my oil cooler with both lines/fittings facing down (fittings vertical).After looking at most of the post on this site i notice that most installs have the oil cooler mounted with the fittings horizontal.Will this cause any problems, should I change the position of my cooler?

I have a Turbonetics manifold for my 1st gen... can any one tell me the thread size / pitch?thanks,

I was planning on changing the fluids in the tranny, transfer case & rear diff. I was wondering what weight fluid i should buy. Redline fluid is real easy for me to get and i can get a real good deal on it. Is this a good gear oil, i heard that BG is one of the best for DSM's. What should i...

I was planning on changing the fluids in the tranny, transfer case & rear diff. I was wondering what weight fluid i should buy. Redline fluid is real easy for me to get and i can get a real good deal on it. Is this a good gear oil, i heard that BG is one of the best for DSM's. What should i...

I was planning on changing the fluids in the tranny, transfer case & rear diff. I was wondering what weight fluid i should buy. Redline fluid is real easy for me to get and i can get a real good deal on it. Is this a good gear oil, i heard that BG is one of the best for DSM's. What should i...

has anyone taken the side ground effects off of there 92-94 Eagle Talon. if so do you know where i can find the metal clips that wedge onto the two prongs on the door ground effect & the one that runs along the rocker and the quarter panel. they are rectangular pieces of metal and hold the...

i have a 1st gen. and i put HKS cams in it 264 in. & 272 ex. i wanted to adjust the aem timing gears just wondering if any one had an idea of how much to adv. or ret. the cams.other mods apexi full exhaust, SAFC, AVC-R, 225l Walbro fuel pump, fuel regulator, stock turbo, 450cc injectors.

if any one knows where i could find the fuse box that holds the ABS, MPI, IGN & Fan fuses. It connects to the positive battery terminal. I need one because the idiot that owned the car before me decided to destroy it so i am trying to find a good one. I need one from a 92-94 with ABS.

i went to drive my car yesterday and when i started it ran for maybe a second then stalled and wouldn't start after that. I checked to fueses at the battery and the MPI fuse blew. Just wanted to check and see if i should just replace it or check for other problems that would have caused it to...

Does any one know the name of the place that rebuilds the IAC Servo's. I heard that there was a web page or a link for it. If any one knows what it is could you let me know.Thanks

There is a hissing noise comming from the drivers side dash. Tried boost gauge not that i ran it with it not hooked up and still does it. Any ideas? It starts to happen at about 5psi and up. And the hiss gets louder as the psi goes up.