So my NT 4g63 was overhauled but since the shop wasn't experienced around old engines it ran like crap.Cold start idle were around 600 rpm, turning on AC would go down to 400-500, I unplugged the coolant temp sensor and idle got better (800-1k rpm). But the major problem is it "chugs" below...
Some background: Had my engine (4g63 NT) overhauled since Oct 2021 due to leaking gaskets, for the following months I keep getting back jobs since the shop was very incompetent (Wrong belt timing, blaming parts they purchased etc.). So after my 3-4 back jobs my Galant became an embarrassing...
Note that my car is a FWD NT 4G63 GalantRecently there's a rattle at the passenger side wheel well area, it occurs at speed and letting off the throttle while in any gear but goes away when stepping on the gas again. However, changing to neutral while moving reduces the speed of the rattling...
So my 1G MAF finally gave up on me and I'm planning to convert to a 2G MAF (449 or 455 JDM equivalent) but I'm having trouble identifying the wiring diagram of the 1G MAF.Basically I've got the top pins sorted (Pin 1-4) but on the lower half is where I'm getting confused, pin 5 doesn't exist...
I have a Galant 92' with a 228k mileage. I recently noticed a very minor oil leak, a 5 minute drive doesn't cause a leak but a 10 minute with constant traffic causes a tiny drop.I've asked my mechanic about replacing the gaskets but pulling the engine out costs about $200. So I was wondering...
Hey guys first post here, I recently got my Galant tuned up (replaced all belts including T-belt, spark plugs, rear engine mount). Now I got a new problem, a knocking noise coming from the middle section of the timing belt cover. It doesn't go away when revving nor when it goes up to operating...
Hey guys, after years of just browsing this website I finally made account due to me finally owning a 4g63 powered car. A Mitsubishi Galant GTi! No turbo and AWD which is perfect in my case since I am just a college student and cannot afford to maintain a rally beast, but here's hoping I will...