Two issues:1. Check Engine light is on: EVAP Emission Control System Purge Valve C-Fault (P0443)
What is this??2. My car has plenty of white smoke coming out when I first start the car in the mornings and when I start the car after it has been run for awhile. The white smoke...
After driving through a rainstorm in So. Cal, I started hearing a slight squeeking noise at the timing belt area on the driver-side wheel well. I looked down and since my timing belt cover for that bottom area is broken, I can see the belt wiggling a little bit.The belt doesn't look like...
I'm having horrible idle. When I start the car, it idles very erratically below 1,000 RPMS. There's no specific rhythm to it, it's very random. The car stutters, thumps, and really feels like it's missing hard.For example, the RPMS could be at 800 one second, then do a sudden drop to 0...
1st AfterDark DSM Meet @ Ortega Fwy (74), Wednesday May 26th @ 11pmExperience the thrills of this Orange County canyon in an exciting afterdark DSM meet on the Wednesday night (less c o p s) before Memorial Day weekend! The 74 FWY in Orange County has many twists, turns, and some hardcore...
More problems... make them stop!When I start my car in the mornings it completely skips the warm-up phase and just idles erratically under 1,000 rpm. It feels like it's missing, then when the car warms up a minute or two later, everything idles fine.Any thoughts on why in the world...
Okay guys,I have some really bad idle surge and I need to buy an ISC motor right away.Do any of you know if the 1g ISC motor will work with my 2g?Thanks much in advance! I'm sure others have asked this question, but I was unable to locate it in the forum.
When I'm driving in overdrive going up hill and trying to hold my speed steady, the car jerks like it's on a very bumpy road. Also, I feel like when I'm pressing the gas, more power is being generated, but it's not being put to the ground.This scares me, what do you guys think this is...
Is it possible to convert the regular low-beam headlight into a high-beam? SO that way we have a high-beam setup in replacement of the low-beam to increase visibility?This question comes about because on the 95-99 Eclipses the low-beam headlights are 1000lumens while the high-beams are...
Anyone have instructions for replacing the fuel filter on a 2g turbo? I looked at VFAQ but didn't find anything.Any thoughts would be appreciated! Where is the fuel filter located? Any tips to get it out? Etc.Thanks
** 97 Eclipse GS-T **I just started hearing this really weird 'ticking' or clicking noise around the dashboard yesterday at low RPMs. It's really starting to concern me and I only hear it at low RPMs, like 500 -> 600rpm. When I bring it up to 1,000rpm, it stops.I have an automatic...
Okay, amuse me for a few moments. Can I remove my exhuast from the o2 housing and run it down the road like that? Or will it cause a lot of things to melt?
DSM Tuners,Are ISC sensors the same for all of our cars? I have a 97 GS-T and my ISC motor has gone bad. I read somewhere that the turbo/non-turbo ISC sensors are all teh same. is this infact true? If so, can I find just any eclipse/talon/laser and take its ISC motor?Please assist...
Alright DSM crew, I need a little bit of guidance here.I have a 97 GS-T automatic and I'm wondering how I change the automatic transmission fluid and where in teh world the fuel filter is located?Many thanks in advance crew.
Are complete free flowing exhuasts bad? For example, my friend who has a gs-t disconnected his exahust from the cat and now has a huge pipe missing.Is this bad for our turbo cars? What does it do? What are the negatives & positives?BTW, his car is L O U D as hell... and annoying
Simple question that I can't seem to find the answer for: What causes aftermarket blow-off-valves, such as the Greddy Type-S to make the blow-off sound louder and neater?Any insights would be ultra-appreciated.
What are some methods to pull check-engine-light codes? Is an OBD-II logger the only route? I have a notebook computer, can I just buy some sort of cable that connects to my ecu and pull the code?Thanks in advance team!
Hey Team DSM,So I'm here looking at my car and thinking i need to feed my turbo addiction. Time for a test pipe!So i've perused through these forums and found the advantages of a test pipe, but nto exactly what it replaces and what needs to be done to install a test-pipe. Can someone...
I just noticed this today, when i hold my RPMs steady at 2000rpm, the exhaust puffs off a steady stream of white-ish, blue-ish looking smoke!So, scared as hell, I took apart my intake inlet pipe to look at the turbo blades adn found it with 4 blades and 4 blades next to it looking all bent...
Hey DSM guys,I got a nasty cop last night pulling me over and cited me for my window tint!! It's to my knowledge that the windows were tinted like that from the factory. I have a 97 GS-T with the rear windows tinted, the passenger, and the driver's side windows tinted. I really believe...
The rear oxygen sensor on the exhaust for the 2Gs may look intimidating to remove/install, but in reality i actually quite easy. Take a look at this step-by-step guide.1.) jack up the car and get a huge wrench that will fit the oxygen sensor. PREP yourself.
2.) Remove the oxygen sensor...
So I have some flexible metal hosing sitting around that I think I may be able to mate with some rubber couplings. If I were to fabricate something to replace the rubber BOV dump tube, do any of you think it would make a difference? In terms of PERFORMANCE? In terms of SOUND?I also have a...
Question here... I have 2 1g BOVs and i'm wondering what effect this will have:To have 2 BOVs on 1 upper intercooler pipe. Having the one closest to the throttle body being recirculated and then having the one furthest from the throttle body being vented to the atmosphere.Any thoughts...
Anyone have recommendations for a suspension setup WITHOUT lowering springs? I'm thinking some adjustable shocks, and all the tie bars and such.Any advice would be ultra-appreciated.
This was NOT written by me but by GSXTCY so he gets all the credit and such. I just want to get some opinions..."CRAZY PIGEON MOD" to make your 1g BOV sound like an aftermarket BOV.If your bov is crushed then the mod will no work to its fullest. You need a non crushed 1g bov. When...
Hey DSM geniuses,When I'm idling at ~800rpm, I can hear this fairly loud 'hissing' sound (like air rushing) coming from my throttle body area. Any one know what this is? I have a 97 GS-T, someone with the same car, can you pls listen and tell me if you hear the same thing? It just doesn't...
Say I'm going in 2nd gear and I hit it hard, the acceleration power curve feels really jagged or awkward. I'll notice subtle stumbles across the powerband but it picks back up immediately.Anyone ever have this problem or what this is indicative of? Pllleeaassee help or provide any guidance!
Hey Techies,How do I extend, in length, my BOV return vacuum that goes from the TOP of the BOV to the throttle body area? The little vacuum is too short and there's a hard kink in it. :(Someone please help! Any thoughts on what sort of vacuum this is or where i can get a larger one?
So the timing belt on my 97 GS-T broke recently and I replaced all of the neccessary parts. Started the car up and everything works fine. There's a very slight vibration now at idle speeds, is it possible that my valve or pistons are out of wack? THe car drives fine, jsut slight vibration at...
Hey DSm'ers,Someone's gotta have a quick answer to this. I blew out my front passenger speaker, how do i remove and replace it? I can't seem to figure out how to take this darn thing off. I removed all of the screws to the door panel, but it just doesn't seem to budge.Any thoughts...