Hey guys, finally had time to start messing with link and my rebuild engine.This is not my first time with link (did my 2G few years ago) but im feeling kinda rusty. Im having some issues and would like yo have some of your input.Engine is a stock rebuild Stock everything beside SD...

Hey guys, im looking to install my SD sensors + WB on my 1G. Im use to 2G but now with my 1G, there is not a lot of input available.i'll be using pin8(MAF) for IAT, pin15 (EGR) for MAP and i would like to retain my stock O2 sensor if possible. Can i log WB signal with the BARO input (pin16)?Thx!

Hey guys,On my 1G i have a set of lightweight 15" wheel. bought the car as a roller shell and tire a shot.As i need a new set of tire, should i stay with the 15" wheel (if so, what size of tire), or should i go back with oem size (16") or if there is any benefit for 17" wheel.I do not plan...

As i'm about to start my engine rebuild, i was looking at the repair manual and i saw different specs for the piston ring gap size.You can take a look herePage 9-15 (Engine specification) and page 9-128 (Piston and Con rod)I'm a bit confused WTF

Im tearing down my engine for a rebuild, notice some discoloration on the rod journal.No hot spot/blueish tint and surface is smooth with like a cross hatch pattern. I'll measure everything but i'll like your input. Crank look super clean. I do not know the condition of the engine prior to...

Hey guys, what are you using to clean old gasket from the mating surface. On both head (aluminum) and block.Is the scrotch brite wheel to corse? My last engine build was like a decade ago, maybe i miss some new tools for the job!Thx

Do you have some tips for a quick transmission inspection (1G AWD). "Suppose" to came from a good running engine/car.For the ones following my build thread, its the tranny from the rotten 1ga i bought a year ago. Never saw it run. I still have some work to do before touching the tranny, but...

Bock submitted a new DSM Profile :Bock's 1G-BA RestoRead more about this vehicle here...

Hi, i bought a bunch of parts a few week ago. Came with an oem new (refurbish maybe?) mitsubishi 20g turbo. Turbo came disassemble, i'm going to put it together with a new rebuild kit and have it balance by a shop.My question are;-the compressor housing have 2 bolt screw in the...

Hi guys,Lot of snow here.. so i was looking at my last log from past summer. I know i still have thing to do with my tune. But, can you tell me how close the wb02 and the AFRationEst should be matching? Should they be spot on? I'm looking at this before tweaking the target AF in DA (too rich...

Bock submitted a new DSM Profile :Bock's Early '95Read more about this vehicle here...

Hi, i'm having some trouble with my low speed relay. It is clicking like crazy (ON/OFF/ON/OFF).Some info about the car : Last summer everything was OK, then park the car in the garage for some maintenance this winter. Had remove engine and accessory to repaint engine bay than everything was...