The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support Rix Racing
Please Support STM Tuned

Search results for query: *

  1. Matthew Mills

    1G ... and now it wont start

    Update - I replaced the end connector to the starter thinking it had corroded, but once it was back together, still no crank. The wire is all bound up in the harness and its really hard to pull anywhere. I did check the wires going to the starter relay and they are all fine. SOOO, i need to...
  2. Matthew Mills

    1G ... and now it wont start

    Update - I had a mechanic friend of mine give me some steps, much like what Brembo said:1) Put car back together. Measure the voltage across the battery when turning the key. If there is a drop it means power is going to the starter but its not cranking. Turns out there was no drop in voltage...
  3. Matthew Mills

    1G ... and now it wont start

    Hello tuners, I had repaired my ECU in a previous thread, thanks a bunch. I took it to get smogged and things were looking good. A few hours after I got it home I tried to start it again and all I get is clicking from under the dash, no crank at all. I looked up the "How to diagnose a...
  4. Matthew Mills

    1990 Mitsubishi Eclipse GSX

    Matthew Mills submitted a new DSM Profile :My ongoing projectRead more about this vehicle here...
  5. Matthew Mills

    1G 1990 Eclipse Help identifying part

    Okay, Update Time. I happen to be handy at electronics (I would not recommend doing it yourself unless you have worked on de-soldering, repairing electronic circuits. Electrical work only will not cut it.) so I took out the bad capacitors, cleaned up the electrolyte with flux and a heat gun...
  6. Matthew Mills

    1G 1990 Eclipse Help identifying part

    OK. I took out the EGR, cleaned it, did a vacuum test and it holds a vacuum. Tested the flow with the vacuum off and on and its working properly.I will definitely replace the gaskets on the throttle body, ISC, etc. and hoses.The solder side of the ECU looks pristine, no weak solders, no...
  7. Matthew Mills

    1G 1990 Eclipse Help identifying part

    Thanks for the advice! I cleaned the throttle body and the ISC. I tested the ohms and the coils are fine. I energized the coils and heard the click as expected but i didn't see any movement. Though if its a stepper motor it would need to be tested by the controller.I took out the ECU and the...
  8. Matthew Mills

    1G 1990 Eclipse Help identifying part

    The sound it was making was like a broken relay. it kept clicking very rapidly and randomly. I took out the throttle body to get at the second bolt, which was stripped and frozen, I had to drill out the bolt head. The intake side was pretty clean on the throttle body but the back side and the...
  9. Matthew Mills

    1G 1990 Eclipse Help identifying part

    Hello, I have been trying to fix my car. It runs poorly, way too rich. On Board Diagnostic says everything is okay. I noticed that when I have the key on and the engine off I hear a strange clicking noise from a part just below the throttle body. Here is a picture of the part, I am pointing at...
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top