I know there few thread about this but not too sure about it. Okay I'm going to tell you of what I did lately on my gst. My dsmlink showing 11.9 battery while engine running so I swap to 1g alternator and I rewired it. I also brought new battery redtop optima. Now my dsmlink graph showing...
I recently got 7 bolt short block for free from my friend but it need to be overhaul. Should I clean them up and sell it to buy 6 bolt or keep it? Just need your simple opinion.
I just brought new acer google chromebook laptop today. Im trying to download the dsmlink v3 software on their site. It say not support it and need to go google app. im not sure what exact app i have to download, but do you guys know which app i have to download or is there a way i can download...
I know there are a lot of forum about the shaft seal but haven't found a clear picture of which side of the shaft seal to install it. Whoever done this, I don't know how you did it to make it simple. I lube it with little bit oil and tap it down with 10mm socket (try both side) and seem messing...
First off, my grammar or sentence may be bad. Im done installing new fmic intercooler and big 16g, and fuel lab fpr. Now it finally start and i took it for road test. When i took off and trying to make boost, the boost gauge stay 0 so i figure that i got boost leak. I did the boost leak tester...
Does this log look normal or temp is good? I just leave it idle for long time and took it around the block that all. That all I'm asking and making sure it look good before I register the car .
:dsm:Okay im going to keep this simple.Install Fuel filter (no leak)
Install 255 Walbro fuel pump (haven't rewire yet)
Install FPR (no leak)
Install FIC 850ccBefore I install all these, engine was running strong, now it a issue after I install all these fuel system parts.
I also have dsmlink...
I just got my dsmlink v3 and I need one more thing to buy is laptop. Well I stop by local performance just to ask question to see what they say. I ask them how much he charge for dyno pull then he ask me if it tuned. I told him I will tuned it soon for my first time. He say "he wouldn't do that...
I have obx high flow cat, I brought it for my 420a but sold it and never install it. I was thinking to cut the flange and weld 3" flange for my gst thermal exhaust. Before I do that, do you think this high flow cat will pass emission? I mean there nothing inside. :idontknow: