All right, normally I don't post here much but my rack and pinion over flow tubes are leaking and today I took some parts off to get a closer look and I found that it is moist by the big nut where the steering shaft goes in. Anyways, started to look for a rack and noticed that everywhere where...
I just put back my dsm back on the road after about 2 years of being under a knife. I have successfully did 4 wheel evo brembo swap on all 4 corners and during that time and my exhaust completely has rusted awey. I will tell you more the muffler completely has fallen off. I was so excited to...
I am replacing rear control arm bushings and the bushing for upper arm are like 5mm bigger then the hole in the arm. What is normally done: make them fit buy heating them up or should I trim?
My arms are ready to be picked up. So I was wondering if anyone had control arms powder coated and the installed bushings and ball joints in them? If so what did you do to prevent damage to the coating? Pictures are welcome.
A little about me and how I got my dsm. Many years ago during high school I wanted a dsm. My mother would not allow me to buy a 1G locally because it looked terrible as the clear coat was peeling on it. As a result I bought a 2g. It was a 1997 in red with beige interior. I loved that thing...
I just picked up a used 90 EPROM ECU for my 90 GSX and I can't connect to it.
Now I have been playing with the lap top ports and make sure everything is connected right and my laptop is recognizing the cable. So that's good.The car starts but I didn't drive on the new ECU. Anyways, so I...