hey guys, was curious to see if anyone has attempted to dump the exhaust out of the quarter panel (side skirt) and how much of the body inside has to be cut away. the reason id like to give this a try is because i seen only one or two eclipses with this setup and i like the look of it, its...

1). Any boost, vac, or exhaust leaks? none2). Verified mechanical timing? yes 3). Verified base timing? yes 4). Ignition system ngk7,ngk wires,new coils5). Motor health (Compression Test) 180 6). Performed basic throttle body adjustments? TPS:.67 volts BISS:needs a little adjustment.sits at...

4G63_Savage submitted a new DSM Profile :Spyder gst buildRead more about this vehicle here...

Hey guys. Does anybody have the wrx side skirt extensions on their 2g spyder? Was gonna buy some but would like to see some first. I can't seem to find any pics anywhere. Thanks in advance

hey guys quick question, I searched but couldn't find anything that will help me out. I just got my head gasket and head studs in the mail today and when I sat the HG on the head just to make sure all was correct, the oil feed does not line up with the oil feed cutout on the head gasket. I'm...

I installed my rod bearings an i rotated it once or twice to install the other pistons and i decided to change my ring gap so when i pulled my rods out i seen thisWhat can this be from? Clearence issue or gunk. My oil clearences on my rods were .002

Hey guys I need help ASAP if I could I have Wiseco piston and rings and my PTW clearance is .0035. Now how does my top ring gapped at .020 and my 2nd ring gapped at .024 sound?i called Wiseco and that about what they told me I just loosened up the bottom ring do to the amount of boost it will see

Quick question about the ARP main and head studs. After I get them to where they need to be torqued at is there like another half turn or something I gotta do?

Hey guys. I'm building my GST and I'm onto installing my rods and pistons in my block. I measured my rod oil clearance and it's at .002. I was wondering if that was to tight? And If I kept it that way, what's the best oil to run? I'm running scat rods with ACL STD bearings

Hey guys. I'm assembling my bottom end on my 98 gst and I purchased Hbeam scat rods and Wiseco pistons and to my knowledge wisecos are a floating wrist pin design correct? And I was wondering what the oil clearance is between the wrist pin and small end of the rod. The wrist pin slides in very...

hey guys, im new to the site so if I made a mistake with where to post or how to post I apologize. im currently building my 98 gst and my main bearing holes will not line up with the oil holes on the block. I don't know what is goin on, this is the 3rd set I ordered thinking maybe they sent the...