I have a few questions regarding shimming my rear differential pinion gear. I am currently rebuilding a 4 bolt rear diff and I have .015” backlash.
Looking for maybe some reference on how much shim to add to the pinion.Also curios if this is a safe website to order a shim pack from...
This issue happened after launching at the track. I can get into every gear just fine. I can get rolling but if I give it gas the rpm’s go up and car does not accelerate. I thought it might be due to a faulty pressure plate or glazed clutch. I just replaced the clutch disk/pp/ and resurfaced...
•Hx35 8 blade
•Archer fab manifold
•Bullseye housing
•tial MVS open dump
on 02 housing
• custom 3" side exitBoost source is at bottom of wastegate(top port vented) and goes directly to compressor housing. 10 psi or 20psi springs set ups really don't change it. Boost just climbs to 25+ psi...
I bought this car with a magnus smim and this professional products 75mm mustang throttle body. Same one thats on extremepsi.
I'm tired of messing with my idle and warming the car up myself. Is there any way to get an isc on this thing?
New gates master and slave. Watched jafro and jacks videos. Tried an extended and oem slave rod. No leaks. pivot ball not shimmed
Unsure of flywheel step height.
Everything seemed fine til I put this used braided hose on.
After a few miles of in town driving I lose my clutch at a stop. Won't let...
Car has been sitting two weeks due to fixing an oil leak. Noticed my tensioner arm is touching the hydraulic tensioner housing. I have only put like 200 miles on this tensioner. Could it be bad already?
I had a pretty good go at installing a cut off switch where the trunk lock was on my 91 talon and I thought I'd share for anybody looking to install one in the future.
i did have to trim the back of the key to get it to rotate without hitting the taillight.I can post more pictures if anybody...