Does anyone know how many pounds the pressure plate in the stage 4 kit is? I'm a little confused cause stage 1 is 2400, stage 2 is 2400 and stage 3 is 2600 but the correlating number on stage 4 is 1620. Stage 4 says it holds 250% more than stock which is significantly more than stage 3 so I...
I'm converting from a 95 to 97 body. I'm posting a pic of the new headlight wiring and the wiring plug from the old headlights. Can anyone tell me which color wires go together. I greatly appreciate it. Thank you!
In the past I used a ACT 3600lb pressure plate with a 6 puck disc, then I tried a Clutchmasters 3600lb pressure plate with a 4 puck sprung ceramic disc. I prefered the 4 puck set up. Now I'm thinking of trying an EXEDY stage 3 pressure plate with a 3 puck sprung ceremetallic disc. Does anyone...
Does anybody know what adaptor I need to fit the A/C charge port on my 95 GSX? I bought what Knechts told me would fit my car, but it doesn't fit. I then called Mitsubishi and their tech didn't know anything. Any help is appreciated.
Does anyone know where I can get ahold of 97-99 headlight connectors/plugs? I'm swapping from 95 headlights and the plugs are different, I called Mitsubishi and they didn't have any help to offer. I appreciate any help.
Does anyone know the sizes/thread for the following parts:The bolts that mount the engine bay fuse box?All the interior screws?Bolts that mount the ECU?Bolts that bolt down the two backseat pieces?Front drivers side and passenger side seats?
I'm ordering them next month and they are available in different offsets, which offset do I need to make the 245's work? Tirerack recommends a +45 but that's for a 215 wide tire.
I have a 95 eclipse gsx and am swapping the headlights for a 96-99. I know I have change the bumper. My question is does anyone have a how to on how to swap the connectors, cause they are different.
I have a stock composite headgasket and I just put in ARP head studs, I torqued them to 80 ft. lbs. with moly lube. Is that enough torque? Should I go up to 90 ft. lbs.? My plan is to run 24psi with my 20g.
I have a stainless steel tubular exhaust manifold and I'm trying to install a EGT probe, the bung I have is zinc is that compatible to weld to my manifold and will it hold up to the exhaust heat?
In the future I plan to run a 25g. In the mean time what's the max boost I can run on pump gas? If I go with the 1000cc, will that be big enough to support the 25g when I'm able to go that route?
I opened the case and on the bottom right of the circuit board there is a black chip 1/2 inch high and 1 1/4 inch wide it has a sticker on it with the numbersEB23A
3214Is this a Eprom ECU?