Ok thank's alot. Also i have read that if you use this cable that you have to run a positive 12v source to the plug that opens the ecu in my 98 gst, the one beside the obd port that only has one wire. Will this work? I have read that the 3rd gen eclipse was letting you do this? Thank's

I accidently pulled my connector off my knock sensor pulling the motor. Does anybody know how which way the 2 wires goes back in the connector? Thank's

Yes as long as you do not use the blue cable one's from china. you have to put a 12v wire to the flash port and a batt charger for safty just in case it my brick ur ecu.

I sure hope ceddy has his website back up. I had all of the roms and stuff downloaded and well my comp crashed and no files but one. I just figured out that you can in deed flash with a vagcom cable so thats good news 20$ cable and solder a wire in to it. If anybody can help with the files i...

I really hate to bring this thread back up on this. I purchased a 409.1 vagcable and used the drivers for open port but still can not get this too work but the one I have is the blue cable. I was just wanting to clarify that this one above does work for 19.99. Im not worried bout the one I have...

I tried jumping pin 1 to pin 4 and it didnt work on my 98 gst and if i ground pin 1 to metal it just blows the door lock fuse. Is there anyway to reprogram my new fobs? Tried using the hazard light button like on 3gs but that didnt work. I put a paperclip in pin 1 to 4 and shut the doors nothing...

Ok so i went back out and re ground the solid yellow wire and the fuel gauge went up to about a quarter of the way so i guess my sending unit is bad thanks for all the replys i greatly appreciate it alot.

Ok so i finally get to the back under the seat today to ground the solid yellow wire and in between the drivers side and passengers side all 3 wire's are broken so i ground the solid yellow wire and my gauge does nothing and then i ground the yellow stripe wire and my low fuel light goes on so i...

Thank's for all the replys. You guy's are the best on helping.

If i posted about the wiring harness my bad but this is the first time i have ever posted about the gas gauge again im sorry. Never kn when some one might read this and have 1.

I have a 98 gst and today i drove it to the store for the first time and i thout it was empty on gas put gas in it but the gas gauge didnt work i have read different post but still dont kn what to check if anyone can help would greatly appreciate it thanks. Also iam looking for the brake light...

Ok i juss tried to jump it over found 2 wires that was black/red and 1 black/yellow tried jumping them over with a piece of wire but it wouldn't engage the starter.

Ok thank's i will juss jump it over then thank's alot...:thumb:

I have a 98 eclipse gst and the starter relay is going out it is a auto but was a 5 speed supposedly it has the clutch pedal still in it and slave cyc. The question i have is i found a relay online for 6 buck's but it says for a auto. Does it matter if it is a 5 speed or auto would they be the...

I hope i am posting in the right spot. I have a 98 gst and im iso a brake wiring harness the car i bought does not have a wiring harness for the brake light's if any one has 1 for a reasonable price ### let me kn thank's

Cool thank's. This site is awesome just about every question i have asked some body has always help and i greatly appreciate it alot thank's again.:thumb:

I was wondering if any body knew where i can buy the 3 o ring seal's for the power steering pump to the line's? My alternator went out and after looking it looks like the leak was at the high pressure on the pump i think it's called a banjo nut. I figured i would just buy all 3 while i was at it...

Yes it looks exactly like that color and all thank's...

My oil pressure was not working so i look up under the car and found a white yellowish wire. Is that the wire for the oil pressure sending unit? I read some where that it suppose to be blue if anyone can help i would greatly appreciate it thank's. 98 gst

I want to thank every one for helping me and reply really thank's a bunch u guy's rock :hellyeah:

Oh i see now the bottom bolt is near the oil filter? I was looking near the tire at the front of the alternator, i seen a nut where the oil filter is i was hoping it wasn't there. Is there a easy way of getting to the nut by the oil filter?

I found out today my alternator has finally died and iam trying to get the alternator off took the top bolt and pivot nut off but can not find where the bottom bolt is i looked at the fender wall on the driverside but didn't see a head for the bolt. I have a 98 gst if anyone can help i would...

It is just the face it doesn't replace the internal gauge's just the factory face like the speedometer,tach,boost,oil pressure,fuel,water temp.

If any one can help i bought some indiglow gauges for my 98 gst and when i remove the boost and oil pressure gauge the needle came out where the oil pressure is. I took a pic of it, can anyone tell me if it goes back together like this? I think i have it together right but want to make sure...

No i notice the water in the back floor board bf i raised the hatch i took the back seat up first and found water under the seat.

That maybe why i had water in there, the passenger side drain hose was pinched together and i took and cut where it was pinched and put the hose back up and clamped it down, idk but it ran up in my passenger back floor board did urs do that to? Thank's

Does anyone know where i can buy a rear hatch gasket? It rained today and water is in the hatch where the spare tire goes and it has runned up in the passenger side floorboard. My drain tube was pinched tho do u think it was bc of that?

Ok let me ask another question. I looked at the auto transmission and only found 1 plugg going to it, is the reverse light plug seperate on the auto? The reason i ask is i noticed on the 5 speed there is a single wire going to it with 2 wires. Im sorry to ask so many question i am new to the...

Yes it looks like some one has wired it in with a connector. Does the 6 bolt motor have a cas? And what do u mean it has been converted ? Do u mean they wired in a cas plug for a 6 bolt swapp?Thank's for the reply.

Should it plug into anything? My check engine light is on but i think its bc my o2 sensors are not plugg in i have my exhaust off. What is the cas? Thanks for the reply.

Can someone ### tell me what this plug goes to it has 3 wire's 1 black,1 red, 1 blue with a red strip? The car is a 98 gst the previous owner said the car use to be a 5 speed and they changed it to a auto,and im going to change it to a 5 speed. I dont think it is a reverse light bc mine lights...

Ok thank's alot..

I tried turning the bulb and it won't even turn like it is stuck or glued in there. Thank's for the reply's.

Hi i was wondering if anybody has the ignition key lock cyclinder and door cyclinder that takes the same key for sale? The eclipse i bought doesnt have the door key but i have the ignition key that will crank it, i been using my keyless remote to get in.If anybody has the set that uses 1 key iam...

Thank's i will this is my first turbo eclipse and i havn't got it tagged yet so i was juss reving it up. I appreciate everybodys reply's on this.

That exactly where i installed the line coming from my boost gauge. Do you think my turbo isnt boosting? I can hear the blowoff valve when i rev it up but the boost gauge only reads like 2 pounds of boost or a lil more.

Hello i am trying to hook a boost gauge in my 98 and i hook the vacuum line up at the fuel pressure solenoid but when it is running it is below the 0 boost like -10 and when i give it some gas it juss goes straight to 0 or the next line like 2. Do i have it hook up right? I hope iam posting in...

How do i go about cleaning the rear drain tube's on the moon roof? The ones at the hatch. I can't get to them from the top the moon roof is in the way i have water behind the passenger and a lil at the driver's side. Thank's

I agree i look every where and couldn't find anything about this, at least now there is something about it. Thank's alot guy's for the help:thumb:

Ok thank's i didn't know there was a adjustment at the pads and i have not check the pads just got the car and havn't got to check them yet with all that is wrong with the car. Is the adjustment at the brake pads? If so is it a screw like at the ebrake? I really appreciate all the replys and to...

Ok i been reading and i tighten my ebrake as far as it will go at the handle and it barley stops the car on a slope i can put it in gear and it will not hold do you think my disc brake pads are worn on the back?:hmm:

I give 600.00 for my 98 gst:applause:

Thank's this help..:thumb:

Thank's this really help...:thumb:

Ok thank's this really helped.:thumb:

Hey i was wondering if i could use this on my stock turbo? Turbo Compressor Housing TD05H Wheel 20g DSM 1g EVO 3 | eBayor maybe this one?Turbo Compressor Housing TD05H Wheel 18g DSM 1g | eBayI have search and have not found anything on building a stock turbo upgrade if any one...

Ok i think i found the leak for the back and it was running up from the back to front the boot was off at the top of the hatch and imma gonna have to clear silicone it so hopefully that fixe's this i will let everyone kn if that was it or not thank's again:thumb:

Ok thank's i will try to trace down the wiring and see.:thumb:ok i found where it come's out of the hatch and it is disconnected, where does it go from there? I looked above the head rest and there are no wire's. Does it run under the back seat?Ok i found where it pluggs in thank's alot i...

Tried to fix rear wiper not gettin no juice to the motor but get juice thru the switch:confused:

A water leak that i can not find and can not get power to my rear wiper motor, switch is fine:banghead: