Alright! Thanks guys for the prompt replies!

Managed to go out and snap a pictureThe arrow is where the screw held the tiny piece of metal.

Would my oil gauge still be reading like it normally does if this is the case?

Was changing my alternator and when I dropped it down below the oil filter I clipped a wire coming from under the said oil filter. It was in a yellowish looking box with a thin metal U(this is what snapped when I hit it) shaped piece that was held in by a single screw. Everything works on the...

The clutch is pretty new(exedy racing clutch) and this trans was from a junkyard with low miles(supposedly) off a 93 lazer.As for gears grinding, its mostly from first to second grinding. It usually doesn't grind if I had first started it, then about 15-20 mins after driving 2nd gear starts to...

Been googling and looking through the forums a bit looking for information about a non-turbo (f5m22 i think) transmission rebuild for my 94 talon. I, for the life of me, can't seem to find anything about non-turbo dsm transmissions. I looked around jacks, and shep, but all of the options they...

Thanks for the replies all! I'm going to pic up a new belt and have it put on and all the pulleys checked to make sure everything is alright!

The belt that runs off the alternator snapped(I'm assuming) off the car while I was driving. It was a pretty wet night. I had recently(about 4 or 5 months ago) had my alternator replaced and everything tightened up. The belt was squealing a lot when I first started it up until It got warm...

Alright I'll have that looked into when I get time. That's two problems down! Thanks for the quick answers guys.

Only took it there because my car guy knows all the technicians that work there since he worked there for a couple years. Locally there is no one I know that I'd know do a good job with this type of vehicle. It's that bad 'round here. I'll probably end up biting the bullet and get a set of...

I can't seem to find replacement springs anywhere I look. Keep finding 2in lowering springs and stuff. I am replacing my shocks/struts with kyb excels g-2's and my car guy said I should get new springs as well. So I've been looking and turned up with nothing. Can't spend an arm and a leg as I...

So far so good. Just trying to get figures for this just incase. Thanks though =)

My mechanic, (Girlfriends brother), is having me get one since he's showing me how to do all the work on the car. He told me to get one or a test pipe, so I'm looking for one since my stock exhaust is all rusted out.

Got a cheap pace setter monza exhaust for my n/t since it was the only full cat back I could find in the limited amount of time I had to search, and now I need a catalytic converter for it.Since it's a 2.5 inch exhaust I can't use an OEM cat for it right?I'll need a 2.5in cat then... So...

Flywheel is just the last piece of the puzzle I need to get back up and moving again ><. I'll give them a call on Monday and see if they can direct me at all! Thanks for your input though!

My tranny locked up so I am replacing it.Replacing Clutch and flywheel at same time since clutch is slipping from a leak on old transmission. Putting on Exedy stage 1 racing clutch. (exedy website says an OEM flywheel is sufficient for this non turbo clutch)Flywheel needs replaced and...

My tranny locked up so I am replacing it.Replacing Clutch and flywheel at same time since clutch is slipping from a leak on old transmission. Putting on Exedy stage 1 racing clutch. (exedy website says an OEM flywheel is sufficient for this non turbo clutch)Flywheel needs replaced and...

Thanks for the replies everyone. Mines going out because previous owner ran the car hard for years at sound comps and its getting worn.

Don't know much about in this department; But I need to upgrade my alternator to be able to handle my stereo equipment. Don't know how to approach this. Will need to be better than stock one to hold up to 2 or 3 batteries. Any suggestions?

Wouldn't still happen to have a fwd 5sp trans would ya? that would fit a 94

Yea mines a 5sp Idk details about the galant. The inventory listing just says 1994 galant. Doesn't say anything about trim level. Thanks for the input though.

my transmission took a crap on my talon (94 non turbo) and I've been looking around for a replacement. But 1g dsm are kinda non existent in my area it seems >.> I found a you-pull yard that has a 94 Galant. I was wondering i that transmission would work in my talon.Also was wondering what...

Plan on getting my baby in working order once i replace tranny/clutch/flywheel. Then going to do the N/t to turbo conversion addressed on the forum til I can find a tsi awd for a rebuild. Can't seem to find one around here. =( Rolling in a 94 talon ES for now though!

Sounds reasonable. My guy went a head and told me to just replace clutch flywheel and tranny. So when I get my taxes back that's what will be going on!I was just searching for the past 45 mins and couldn't find an answer with the keywords I tried. Will a turbo 1g Tranny fit in my nt car if I...

I was just driving down the road, heard a horrible loud grinding noise, popped her into neutral to take a turn, then got it back into first, then as i was downshifting to take another turn not even 20 seconds later, my front passenger wheel locks up and wont move forward. this happened smack dab...

Will do! thanks, just gotta wait til next pay check for the tires ><

Recently replaced CV shafts, outter tie rods,and Lower control arms. Need new tires as they are past bald. 94 talon n/tWhile driving my wheel veers left or right a few seconds at a time. Mostly to the left pretty hard. Steering is still as responsive as ever, So if i turn the wheel a...

awesome! thanks. I assumed it would be a little more complicated than just the bearing.Thanks for this info as well!

Went to auto zone because the tire place that just replaced my lower control arms says I need a new hub assembly as well. So I went to auto zone to price them and their computer says it doesn't exist for the car. So what part am I supposed to be looking for? She's a 94 talon non-turbo

Yea, I'm only driving her back and forth to work til this is fixed, less than a 3 minute commute. Just keeping the windows down!

thank's that was easy enough

In the mornings on start up I am getting a lot of exhaust fumes up in the car, have to drive with the windows down. And at 4:45am when I go to work it's pretty cold. Looking under the car the flex tube has a few unsightly holes in it, and where it connects to the pipes down there it's loose and...

As soon as I start Up my Talon (94 es non-t) it whines... a lot. Stops after about 30 seconds or so, but will continue to squeal when put in gear and given gas (from a stop sign or slowing down and downshifting.) This I assume is just a belt issue(I hope) ,and plan to get the belts replaced...

Nothing, just getting older and I was looking to get an idea on what to save up for so when it does go out on me, I can drop a little more get up and go than the stock. lol

I am curious as to where to look for a different engine that will fit into my 94 talon es. Currently has the stock 2.0L non turbo. A google search provided me with little help. I think it actually set me back... -.- Any point in the right direction would be helpful and appreciated!

Looking to replace clutch and got directed to a Centerforce stage 1 Clutch by aa mechanic friend of mine. Can't seem to find a flywheel that is reliable and that will hold up with that clutch. As far as I remember he said he put a Zoom clutch kit on it and flywheel. Any suggestions on where I...

I believe the clutch is new (aside from the car being garaged for a good 2 years without being driven). And yea it was a rear main seal that he gave me. Just forgot the name. All my fluids are full so I didn't think anything was leaking. But I'll look into it. Thanks ^^

Been having problems in third, fourth, and fifth gear with over revving when I'm accelerating. First and second are fine, but when I go into third and hit the gas and get above 4k rpm(this goes for 4th and 5th as well) it will shoot up to about 6 or 7k rpm until I let up on the gas then east...