I am looking for someone to remote tune my car. I have DSM Link 2.5 with a 20g that I just put on as an upgrade from the 16g that I had before.Currently I have it set at 16psi with pretty low timing. I am looking to bump it up a little and get it running with Some more timing. Please PM me if...

Just seized my 16G yesterday...(My fault)Anybody have a 20G or 16G they are looking to sell? I am still using the J pipe with my intercooler system FYILooking to buy immediately.

I have the innovate motorsports MTX-L Wideband and I could not be happier. When i first installed the gauge and hooked it up to my DSMlink I noticed It was off by about .1-.3 AFR. Very minimal so i looked past it. A few months later i am now having to retune since I completely redesigned my...

Hi guys I have included a datalog that I just made. It is a 3rd gear pull to about 7000 rpms.My problem is that I seem to have no power after 5500-6000 rpms. The car is very quick right up to that point.Please lok at my log and let me know what you think. My gauge is showing an almost...

How do i post a dsmlink datalog for review?Do i just save my run and load it up? Better yet, do i have that privilege in newbie status?My car is falling on its face at like 4500 rpms and figure if I make a datalogged run i could get some insight.

So I have what i believe to be a Big 16G turbo setup with a front mount intercooler kit and i am pretty sure I have exceeded it's efficiency at about 24 PSI, so it is time to go bigger.My understanding is that a 20G will bolt right up to my manifold still and work with my current water and...

Anybody local want to do a quick weld on aluminum for me? cash dollars available :-) Please let me know, i can come to you. Trying to avoid a 80$ minimum bill at a shop for a simple little weld.

I am looking to pick up a new Walbro 255LPH fuel pump. Anyone know of a shop in the Everett-Seattle area that has these in stock so i can go pick one up today after work? Trying to avoid buying online and waiting for shipping etc.Any thought would be helpful, thanks. Also if anyone happens to...

I have dsmlink V2 and i am trying to hookup my Innovate wideband for data logging. I hooked it up on my 1g through pin 15, being the exhaust temp sensor.My wideband is running just fine with the gauge, but i cannot get it to show anything on the live dsmlink datalog. I assume i need a buffer...

This is My solution to boost creep, which has worked absolutely flawlessly for me. Please read on to see my how to, which has cost a total of 65$ for the modifications and about 1.5 hours of my time to do.So as a new DSM owner, I have been searching extensively for a solution to my boost...

Should have posted in the local forum early, so this is a double post.Is Pina Motorsports still open? I cannot seem to get ahold of them, for over a week now.

Why is it that i have not been able to get a hold of Pina Motorsports for the past week? Are they still in business? I have searched and found nothing to think they have shut down.Bump. Anyone?