hey guys , im in the process of swapping my old tired 7 bolt head out of a ported 1g head. I know I need a 1g thermostat housing and lower rad hose, but what do I do as far as the coolant temp sensor goes?? will a 2g sensor fit in a 1g housing ?
can some one please help me and clear this up, i have a hy35 on my 2g, i bought a weild on flange similer to the link below. Any way when i built the car i called the local dodge dealer since the turbos off 01 cummins and ask them for a gasket between the turbo and downpipe flange, they told me...
ok im compleatly lost ,my 97 talon is not starting so i probed my injectors with a dvom and im only pulseing like 1.50 to 2.00 volts , to my understandng im saposed to have battervoltage at the injectors, probed the power wire goin into the injector resistor and it has battery voltage there, so...
hello everyone, so i went to start my car today after a fresh build , it started right up and sounded great, i went to give the car a little gas and the rpm gauge went crazy reading well over redline and moving all over the place, it compleatly normal in dsm link, i know link gets its rpm signal...
so i had a innovative lc1 wired to my ecu sensor ground , for some reason it fried my sensor ground, so i sent the computer back to ecm link and got it repaired, i have since removed the lc1 . today i put the ecu back in the car and started a data log and my coolant temps are reading -74 may map...
im finnaly getting around to finish installing my holset hy35 on my 97 talon and im running into clearence issues with the bolt for the turbo coolant line. i know ive seen people shave the bolt for more room but since the turbo is non watercooled can i just remove the bolt and install a pipe...
hey guys , i just bought a comp stage 5 clutch for my 2g project . so my question is i have a brand new oem mitsu throwout bearing and i have the brand new one that came with the comp clutch. i know some people have had issues with aftermaket tob . should i use the oem or comp throw out bearing...
so i picked up a holset hy35 today for my build. im looking to order the oil feed lines and extream psi shows 2 different sizes for holset turbos. can any one tell me witch feed in the hy takes? EXTREME PSI : Your #1 Source for In Stock Performance Parts
anybody have any tips for installing wiseco piston curclips? i tryed putting them in with my hands like you would on a dirtbike but there so stiff i cant squeeze them with my fingers . any tips ?
hello everyone, my names lou some of you may know me.im from pittsburgh, i have a 97 talon tsi awd, i bought the car 5 mounths ago. i bought it to be a project car, when i got it the rockers where rusted out the strut towers were junk it ran like crap for a few reasons, the good is that it came...
hello everyone, my names lou some of you may know me.im from pennhills, i have a 97 talon tsi awd, i bought the car 5 mounths ago. i bought it to be a project car, when i got it the rockers where rusted out the strut towers were junk it ran like crap for a few reasons, the good is that it came...