In the process of putting together a 95 Talon tsi. I installed an engine wiring harness from what i believe came from a 98 auto and there are two plugs on the inside of the car that i can't for the life of me seem to locate their mates. Can anyone give me some information on what these plugs...
I have been collecting parts to perform an auto swap on my 95 Talon. I originally purchased an Auto T-case used from a 1995 Talon. Upon inspecting the case the transfer case was locked up. I contacted the seller and was told that they had another in stock that they would send me. When I...
I am running a Venom Intake manifold on my car. In order to clear the intake manifold it will require me to spin my TPS 180 degrees. Is this correct or is there another way I should be about this?
I am installing speed density on my car and need some assistance installing it. I will be wiring the IAT and the 4 Bar MAP into my GM MAF cable since the wires have already been separated for them. I am wondering if anyone can show me a diagram or tell me how to wire it. I found this article...
I tried searching for an answer to this but had no luck. If it has been discussed in the past and I missed it I apologize in advance.Here is my question. Current the only O2 sensor that I have in my car is the one that came with my Innovate LC-1. I am not running a stock O2 sensor. What...
I rebuilt the engine in my 92 Talon TSi. I have installed everything and I can not get it to start. When I turn the key I can hear the starter but nothing else happens. When I floor the gas pedal the car turns over. However, it is really choppy and dies as soon as I let of the gas. As far...
I am trying to install a Venom Fuel rail that I bought used from someone locally. Upon putting them back together it seems that the fuel rail does not sit flush against the 3 spacers like the OEM rail does. I am wondering if there are suppose to be after market spacers that come with this fuel...
Ok so I have looked and looked and looked for the answer to this question and I am not having any what so ever so I though I would post it here. Here in the next couple of months I would like to build a stroker kit for my car. Currently I have a 4g64 bottom end that has a crank in it. I am...
So I have done plenty of research on what is needed to complete this and have found a few donor cars at a locate junkyard so I am pretty sure that I am not going to have an issue getting the parts of of it. However one question that I have though its what do you need to have the Non - Abs...
Can anyone show me where I can find a diagram of the fuses on the battery terminal. I have looked for quite sometime and can not find one. The previous owner of the car bridged one of the connects with a piece of wire instead of replacing the fuse so I need to see what the fuse goes to and how...