I’m chasing a crank no start issue where the injectors are not firing. Have 2 ecu on hand, one with link and other unmodified. Looking for a member who would plug both my ecu into their car and see if their car would start. Portland/Vancouver/Longview area prefered but can drive further on my...
Hi. I thought I would like to share. Needed replacement piping and banjo bolts, and figured I should share what I used.These are parts off of a 2008 Chevy duramax 6.6 bus that we have. Used it as reference when I ordered new parts from general motors. I had to remove about a half an...
Check engine light states I got a knock sensor failure. Replaced it with another knock sensor but this time it's only plugged in and resting on the fender. Same code. I believe it's a wiring issue and not a sensor issue. Will it cause a problem if I rewire the sensor directly to the ecu? Ie run...
My talon sat for just over a year with a bad clutch. Finally got around to replacing the clutch this last week and my speedo is off. Cruising in fourth gear 2k rpm sand recorded speed is 15mph. Is the year of having the car sit caused a bad speedo in the cluster or a bad speed sensor in the...
I just ordered parts from the local dealership and the parts guy said that the small mirror covers above the door pannel is obsolete. 1995 Mitsubishi eclipse parts for my talon. Did I miss something?
Just got my transmission out. Transfer case is really hard go take out. Especially when you forget one bolt. :ohdamn: I found out the center section isn't connected to the clutch disc anymore, pressure plate still good, tob is really dirty, and the spring to hold the tob is missing. :hmm: New...
I am sorry for the newbie question. I am installing a timing belt without the balance shaft installed. I have the elimination kit. How important is the oil pimp gear timing marks?I have researched the vfaq and it says the timing marks are important because of the balance shaft already...
I ordered my shortblock through maperformance because they gave me a better deal. I'm also sending my head to the machine shop to get it cleaned and checked for bent valves. I'm now broke for a while now and it doesn't help that the holidays are tight around the corner.My question is this...
Pulled the motor out of my car maybe 4 months ago and removed the head. Connecting rod for cyl 1 broke in half. It's been down for so long waiting for me to get parts and rebuild it but it'll be faster to get it back on the road if I bought one from the Internet. Slowboy racing has a lot of...
New guy here. My daily driver at the moment is my talon Tsi awd. Gotta rebuild my mightymax engine so I can use it instead of the talon to work. Which is why I'm here. Looking to get some opinions and feedback from other members here and maybe browse the classifieds cause it's really hard to...