Following my thread https://www.dsmtuners.com/threads/bolt-on-turbo-recommendation.534633/ i want to post here my experience, information and the results from this turbo.Currently I'm still road tuning and because I don't spend a lot of time for the car it will take few weeks for the end...

I know the Series 2 is an old platform but many people still using it, at least i am and i still like it. I want to provide some information that I haven't seen nowhere else and i know many still have a bit of a hard time to tune the idle.Below you see some measurements I did with different...

Does anyone know how to use the Lookup tables in AEMdata maths? I want to convert a Voltage to temperature and the graph is not linear so I can't use just a formula. I created a table with the data voltage/temperature but i can't figure out how to use it to the maths.

2.0 long rod, 8.8 CR, ported head, standard size valves, kelfords 272, ID1000 injectors, walbro450, AEM series 2. Currently i have a td05-20g with billet compressor wheel and 9 blade turbine wheel. I want to upgrade to something bigger with more top end power. The car is FWD running only on...

Here is a simple oil pan baffle that will help to keep the oil around the pick up tube specially at sudden turns, acceleration and deceleration. I don't think will be any good at long turns where the oil will have enough time to escape but sure is better than nothing, is cheap and easy to...

Did anybody else wondered what is the purpose of this piece of gasket that just hanging between the block and the front case? I thought removing it would help a bit the flow in to the pan.

Just some info for you guys. Manley I beam rods with 3/8 ARP 2000 bolts and 40172 lube (loctite heavy duty anti-seize). Manley recommends to tighten the bolts 45-50 ft/lbs in order to stretch the bolts 0.0058"-0.0062". When first i rebuild my engine about 2 years ago in order to stretch the...

Hi all, I want to share some useful info with you guys.Last year I had a bad batch of fuel and I melt a piston. My engine is a 6 bolt, 2.0 long rod with 9.4:1 compression, custom JE pistons 0.02” overbore and 272 kelford cams. The car was running great for 2 years at 26 psi boost with 93...

My car is a Mitsubishi Lancer with a vr4 ECI 92' engine and a complete vr4 harness. My next step is to put ECMlink V3 on it and also remove MAS. As i know to configure the ecm is through OBD... the problem is that my obd has only two pins in it.... is that normal?? also i found another two...

Hello from Cyprus! I recently bought a 92' galant with vr4 engine (the one with the yellow injectors). the car is running with 17psi boost and air/fuel ratio with full throttle is 10-11. While driving the car i found that from 4000rpm to 6500rpm the engine needs some time to rise the rpm's and i...