I wasn't certain where I should post this. Does anyone have a 4g63 crankshaft sprocket (not the harmonic balancer) laying around that they could measure the inner diameter not including the keyway. Also, another measurement that includes the keyway please. I thought I had one laying around...

07 Mustang GT 4.6L 5 speed, 37,000 milesJust thought I would share :)

Car: Built 1992 Eagle Talon n/tWell after living without power steering for roughly a year now I've finally enough funding to commence my electro-hydraulic steering conversion. The pump I will be using is from a 2000-2005 Toyota MR2. This pump has a built in reservoir and a built in computer...

I just built a new motor for my '92 Talon, and dropped it in a few weeks ago. I've put about 500 miles on the motor since the build, and had it dyno tuned. I run n/t (my setup is posted on my profile) and the car runs strong throughout the rpm range. I've noticed a loss of power when I take a...

Just put in the motor I finally finished building. When I went to crank the motor here's what happened:First was a hard start, felt like something was "catching" the motor when it was trying to turn over. When it finally turned over, there was a strong burning smell and the front tires were...

new setup: evo 9 pistons (.02 over), evo 8 valvetrain, g4cn (4g67) head, hks 264/272 cams, 6 bolt 4g63 block (machine shop decked the crap out of it).Projected cr 10:1I have no safc currently, but plan on getting one around christmas. Until then, should I advance my timing a couple of...

I just completed building the new motor that will go in my 1g Talon. 4g63 block (shop decked the crap out of it), Evo 9 pistons, HKS 264/272 delta cams, modified 1g MAS, evo 8 valve springs, 4g67 head w/ valve job and resurface.I plan on dropping the motor in this coming weekend. I have not...

I'm currently building an engine to put in my '92 n/t talon, and while I was removing all the accessories on the old motor my upper radiator neck came off in the upper radiator hose WTFMy question is, since this car is only for street use should I get a factory replacement radiator with...

Where y'all at? Feeling kinda alone here....

I blew my stock tansmission in my 1992 n/t fwd 6 bolt Talon, and didn't want to go back to a factory 1g transmission due to the fact that the two 1g transmissions that had already been installed previously both shifted like crap. I didn't have the cash for a performance transmission build and...

Website will not allow me to post in the short block section yet, so here it goes. I've read til my eyes bled on this subject and now just need some clarification for a n/t application.Some of you know of my recent transmission catastrophe, and were very helpful in providing information to...

I have a 1g n/t 4g63 engine. My stock transmission cracked into 6 different pieces, so I am installing a 2g turbo transsmission in my 1992 fwd eagle talon.My question is, what is the best way to handle the different fwd axle sizes? Can I use the 2g axles, or are they too different from the...

Okay here is the next question. 1G n/t tranny to 2G turbo tranny will the clutch that I took off the 1G n/t tranny fit the 2G turbo transmission? 1G n/t tranny to 2G turbo tranny conversion for a front wheel drive application. I am using a 1G turbo Fidanza flywheel fwd. Chris

All the mismatched information on the forum has begun to blow my mind, and I just need a straight answer for my application.I have a 6 bolt 1992 eagle talon n/t 4g63 that is my daily driver. My transmission is now in 4 pieces so I'm replacing it with a 2g turbo transmission. My question is...

Couldn't post this in the drivetrain forums, so here is my dilemma.I have a 1992 eagle talon n/t fwd and the transmission has split in two. I've read about people using the 2g awd transmissions in 1g awd DSM's, but I was wondering if this can be done with the fwd n/t DSM's. My transmission...

I drive a 1992 eagle talon n/t fwd. I've done quite a bit of work on it myself, and the other day it started grinding on start. I kept driving it and then it quit starting all together, but I could hear the fuel pump pushing fuel through the lines. I could get the car to start if I put the car...