I've included a log when I try to start my car. Recently replaced head gasket and installed the following parts:
FP 68hta
Sheet metal intake manifold
850cc injectors
255 fuel pump
external wastegate
FMIC
The plugs and wires are gapped and hooked up correctly and all the connections in the engine bay should be correct. Please take a look and see if I've done something wrong. Im super excited to drive after these new parts to see the difference.

Also has a S90 throttle body

Have you done a boost leak test

The car is likely running extremely rich. Dial down the deadtime to zero and start there. Also, your intake temp pin needs to be changed back to factory under pin assignments.

^^^Even though I'm running a Omni 4bar mdp sensor?

You have your map sensor listed under 2 different pins so correct that.

Change the intake temp connected sensor to Factory/none. And uncheck "Lock intake temp and baro pressure". Also don't forget to adjust the TPS properly.