Fishytaco10
Proven Member
- 33
- 6
- Aug 28, 2020
-
Orlando,
Florida
Good morning,
So I am a noobie when it comes to rebuilding/stroker build. Long story I purchased a 98 gst shell with tranny, full exhaust only. I gathered other parts already have them posted in the comments on my build thread. They guy I purchased the car from has a bottom end 2.3L stroker build, I asked him is the bottom end fully built he said yes. That I would just need to have the top end resurfaced and add a manifold. Can you guys think of anything else I might need and maybe elaborate on the fully built bottom end? I asked him was all the internals and everything already in and he said yes but I feel like there’s more to it then just that. Again I’ve never done this so any help is appreciated and I apologize if this lost is a little vague.
List of what I have so far some of the items are because they were missing from the car and I needed them. Not all engine related
couple parts I will be picking up on the 15th next week.
Clutch
Fuel pump
20g turbo
Injen intake
Engine harness
Oil pan
Aem gauges
Intake manifold
Fully built 2.3 stroked engine(bottom end)
4g63 top end ( needs resurfaced)
Alternator
Starter
Battery
Ac compressor.
Parts I have already:
Stock ECU
Stock TCM
Intercooler and piping
Blowoff valve
Fluidyne radiator
Greddy exhaust (turbo back)
shifter and knob (original was sold)
Factory sunroof (Original was sold)
crash bar (original was taken off probably sold)
Cars lowered not sure on what haven’t really looked focus has been on getting it running.
So I am a noobie when it comes to rebuilding/stroker build. Long story I purchased a 98 gst shell with tranny, full exhaust only. I gathered other parts already have them posted in the comments on my build thread. They guy I purchased the car from has a bottom end 2.3L stroker build, I asked him is the bottom end fully built he said yes. That I would just need to have the top end resurfaced and add a manifold. Can you guys think of anything else I might need and maybe elaborate on the fully built bottom end? I asked him was all the internals and everything already in and he said yes but I feel like there’s more to it then just that. Again I’ve never done this so any help is appreciated and I apologize if this lost is a little vague.
List of what I have so far some of the items are because they were missing from the car and I needed them. Not all engine related
couple parts I will be picking up on the 15th next week.
Clutch
Fuel pump
20g turbo
Injen intake
Engine harness
Oil pan
Aem gauges
Intake manifold
Fully built 2.3 stroked engine(bottom end)
4g63 top end ( needs resurfaced)
Alternator
Starter
Battery
Ac compressor.
Parts I have already:
Stock ECU
Stock TCM
Intercooler and piping
Blowoff valve
Fluidyne radiator
Greddy exhaust (turbo back)
shifter and knob (original was sold)
Factory sunroof (Original was sold)
crash bar (original was taken off probably sold)
Cars lowered not sure on what haven’t really looked focus has been on getting it running.
You must be logged in to view this image or video.
Picture of under my hoodAttachments
Last edited by a moderator: