The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Morrison Fabrication

Build finally ready.

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

503oneG

Proven Member
30
11
Sep 25, 2020
Beaverton, Oregon
So here is my setup, 6 bolt 4g63. Stock head, ARP head studs, JE 85.5mm piston. K1 racing h beams, ACL race bearings, Holset hy35, tubular manifold. Link v3 with innovative lc2. FIC 850cc, I know there is a thread for this but was hoping for a decently quick response. Say 25-28 psi ish what can I expect for power? This is an AWD manual trans. The motor is brand new built by me. Thank you, Seth
 

Attachments

  • 1347F08D-4281-400E-AFD2-F20403E1B058.jpeg
    1347F08D-4281-400E-AFD2-F20403E1B058.jpeg
    975.5 KB · Views: 29
I was also curious about that. I need to start looking around for 1200 or larger. You think 850 is capable north of 400?
 
Depends on the fuel. I tune a hy35 car with a walbro 450 and 1250cc and at 29-30psi its around 70%IDC and logging 50-52lb/min. This is on E85 tested at 85%.
 
Did it make good power?
Depends on the fuel. I tune a hy35 car with a walbro 450 and 1250cc and at 29-30psi its around 70%IDC and logging 50-52lb/min. This is on E85 tested at 85%.
 
Has not been on a dyno. So all i can go off is the lb/min it logged. It should be in the high 400hp range. The car had more in it but on light wastegate spring and a manual boost controller only using lower port on gate so would not make anymore boost then that.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top