OrlandoDSM
Probationary Member
- 25
- 4
- Oct 17, 2010
-
valley stream,
New_York
Trying to replace my slave cylinder, the two 12mm bolts that are on now are incredibly tight. I feel like I'm destroying the head of the bolt but trying to do it with a ratchet.I was thinking about using an impact wrench to take them out. Good idea or no? The bolts dont seem to be rusted at all but I'm starting to think that the two 12mm bolts were impacted on. I know I can remove the front engine mount to get one of them but the other one is just as tight.