The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Rix Racing

1G Manual trans problem

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Carlos103183

Probationary Member
10
0
Apr 15, 2020
Rochester, New_York
Ok guy I have a problem with my 1g dsm fwd I can’t get it into any gears I replaced the master cylinder and slave I bleed everything and still doing the same thing if anybody had this problem please let me know wats the problem and the solution I can’t wait to drive this 1g
 
were there symptoms leading up to this? Clutch not disengaging will lock you out of gear. Cause can be broken clutch components or a broken clutch pedal. If pedal feels normal i would suspect the clutch itself. Happened to me twice on two different cars. Disc slipped a spring. Pedal felt normal but clutch would not disengage.
 
were there symptoms leading up to this? Clutch not disengaging will lock you out of gear. Cause can be broken clutch components or a broken clutch pedal. If pedal feels normal i would suspect the clutch itself. Happened to me twice on two different cars. Disc slipped a spring. Pedal felt normal but clutch would not disengage.
Ok I replace the clutch and master and slve cylinder i bleed the system it goes on gear when it off but when running it dnt
 
Ok mine pedal is all the way to the end

I don’t know if it supposed to go like that
 

Attachments

  • B6778473-740A-419C-9D20-8E8CDAB61356.jpeg
    B6778473-740A-419C-9D20-8E8CDAB61356.jpeg
    558.1 KB · Views: 125
Last edited by a moderator:
What is the step height of the flywheel? Did you bench bleed the master cylinder? Do you have the correct slave as there are two different diameters. Is the clutch pedal assembly working properly? Did you look and test it?
 
What is the step height of the flywheel? Did you bench bleed the master cylinder? Do you have the correct slave as there are two different diameters. Is the clutch pedal assembly working properly? Did you look and test it?
Which is the right one I’m new to this
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top