AustinGreyson
Probationary Member
- 1
- 0
- May 23, 2020
-
USA,
Illinois
Trying to reassemble my front knuckle (90 gsx). New bearing went in fine. Hub rotated nicely until the last bit of install and is now very stiff. Not like bearing binding, and now thinking seal is backwards. Checked the Timken catalog, and conformed correct part # on box. Per the photo of same seal below, I had the lip pointed toward hub. Was it supposed to go toward the bearing? Didn’t seem like there was enough room, but never done one of these.
You may now laugh at my expense.
You may now laugh at my expense.