Hey guys, last year i purchased a unfinished GST build to bring back to life, I’m going to install my GM style Omni 4 bar map sensor, my car doesn’t have a MAP in it yet. I’m told that this plug in this photo I provided that is not plugged in is the MDP and to cut it to wire my new map sensor, is that correct? If so, my map sensor has a red, blue, and black wire, but the sensor on the car has a green with light green stripe, and a green with black stripe, and a black. I’m trying to figure what color needs connected to eachother.
Also if I’m just wait off, please help a brotha out, lots of quarantine time I’m trying to get this sweet car out there on the road again and I’m learning every step of the way.

You can use the MDP connector if you have ECMLink or so.
MDP Green/Yellow - MAP Red
MDP Light Green/Black - MAP Blue (Or the middle pin)
MDP Black - MAP Black

DSMPT said:

You can use the MDP connector if you have ECMLink or so.
MDP Green/Yellow - MAP Red
MDP Light Green/Black - MAP Blue (Or the middle pin)
MDP Black - MAP Black

Click to expand...

thank you so much! I do have ECMlink i just got dsmlinkv3