- Thread starter
- #126
AWD-Tony
Proven Member
- 6,801
- 3,735
- Sep 11, 2017
-
Cincinnati,
Ohio
6th test and they’re looking more consistent. Max of .03 difference.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Are you doing these all at once? I do each one individually.
Are these metric? ALWAYS POST UNITS.I’ve done the solder test 5 times letting it sit for 12 hours minimum. First time was in the cold garage and the rest have been inside on my kitchen floor. I can’t seem to get a good consistent measurement. Below is the difference I’m getting between all the measurements
Input .109
Intermediate .044
Center diff .031
Output .110
Front diff .072
Could it be possible that the case where the bearings ride are too far gone?
Are these metric? ALWAYS POST UNITS.
So, zero values so far are:
Input Shaft 0.0450"
Intermediate Shaft 0.0405"
Front Diff 0.045"
Those numbers all sound accurate range.