The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support Kiggly Racing
Please Support ExtremePSI

ECMlink no idle

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

goonie

15+ Year Contributor
251
4
Mar 2, 2004
soutomaior/spain, Europe
hi
i am running a race throttlebody with no biss no isc
cant get the engine to idle
unless i lock throttleplate at 5% is there a way to adjust this in ecm link?
i set the idle at various values in link but engine dont respond

any ideas?

thnx
 
Does it have an adjustable TPS?
 
Physically set the TPS manually for .65v/0% throttle. If you still show any % of throttle you can use the tab in link to set it to a -1 or -2 or whatever it takes to show 0%.
 
Ok, so I am looking at your log while I am at work and I see Excessive TPS adjustments that need to be taken care of MANUALLY, but you say that you are at .64V and 0% throttle.
I don't see an idle stop switch so I say you need to "enable idle switch operation"
See my screenshots and see if that helps.
The TPS is way out of adjustment, but try the idle switch box and enable it and see how it reacts.
I have NEVER seen a TPS so far adjusted and I think that is the whole problem.
Is there a reason you need that throttle body? I run a stock 1g and make plenty of go go.
Does that throttle body have an idle stop screw or bolt but no switch in it?
I also see that your O2 sensor is not cycling. You, in my opinion, need to simulate the narrowband with your wideband and I see that is not enabled either. That SHOULD get the o2 sensor cycling at idle.
Marty
You must be logged in to view this image or video.
You must be logged in to view this image or video.
 
hi there
i did enable idle switch but no changes
and yes the throttlebody has an idle stop screw but no switch
i simulated narrowband but still no cycle from o2
i attached a few logs maybe my setting are all wrong
driving the car today for the first time but it overheats
pulled the thermostat but still overheats when driving any ideas?
thnx
 

Attachments

  • log.2019.10.08-01.elg
    9.9 KB · Views: 17
  • log.2019.10.08-17.elg
    36 KB · Views: 16
  • log.2019.10.08-13.elg
    26.5 KB · Views: 18
I tuned a buddies car with a s90 with no ISC. Even when car is cold he has to hold throttle until it warms up then idles as it should. I have tried to talk him into putting a ISC back on it but he refused.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top