Mham2k
15+ Year Contributor
- 306
- 57
- Feb 8, 2008
-
Dallas,
Texas
I followed this write up. http://dsmhangout.forumotion.com/t107-ecmlink-switchable-tunes-write-up
I have read all of the Aux Maps posts I can find and believe I understand most of it but I can't seem to get the MinOct and Max Oct Timing maps to work correctly.
I have a pressure switch that turns the Idle SW Pin from 0 to 1 when the meth builds enough pressure in the line. This should then switch to use the MaxOct Map, this doesn't seems to be working. However, it is pulling fuel out when the Idle SW pin cuts on no problem.
I have tried changing both maps to see which one it uses, it seems to always use the one with the lowest timing.
Temps are between 180 and 190, no knock, and the timing sliders are all 0.
My boxes are checked just like this.
http://www.supermotors.net/getfile/865300/fullsize/untitled.jpg
I don't know what i'm doing wrong... I will post a log when i get home to show you my settings.
Thanks
I have read all of the Aux Maps posts I can find and believe I understand most of it but I can't seem to get the MinOct and Max Oct Timing maps to work correctly.
I have a pressure switch that turns the Idle SW Pin from 0 to 1 when the meth builds enough pressure in the line. This should then switch to use the MaxOct Map, this doesn't seems to be working. However, it is pulling fuel out when the Idle SW pin cuts on no problem.
I have tried changing both maps to see which one it uses, it seems to always use the one with the lowest timing.
Temps are between 180 and 190, no knock, and the timing sliders are all 0.
My boxes are checked just like this.
http://www.supermotors.net/getfile/865300/fullsize/untitled.jpg
I don't know what i'm doing wrong... I will post a log when i get home to show you my settings.
Thanks