aspekt9
15+ Year Contributor
- 344
- 4
- Dec 25, 2005
-
Boston,
Massachusetts
I'm trying to figure out if my knock sensor is working properly. I've been driving around pushing 20psi and the knock count never goes above 0 degrees. I find it hard to believe that I'm not knocking at all. So here's my question, is there a way to test the knock sensor is connected / working properly? I'm using an NT wiring harness, so I had the run the wires myself, however when I was using the palm logger it picked up knock, so I'm leaning toowards the sensor itself is bad. Willl ECMLink show a value (0) if the wiring is hooked up incorrectly? Is there a voltage output to check for?