4pistons
20+ Year Contributor
- 614
- 24
- Nov 13, 2002
-
Port Charlotte,
Florida
Put together a Ram Air/Freash Air intake on my '91 GSX for about $15 using the stock SMIC ducting (I no longer have the stock side mount IC) some dryer ducting, scrap ploycarb sheet, and some fabrication.
I carefully cut the polycarb sheet to fit the back of the stock duct so the round dryer duct would fit it. Routed it up into a hole I cut under the MAF air filter, where the original IC piping was, and attached the dryer ducting. A little spray paint prettied it up a bit and blended it in a little.
While technically not "Ram Air" because it's not sealed to the MAF, it does provide for a constant flow of fresh cool air while moving. It should also provide a slightly positive pressure to displace any hot under-hood air around the filter.
I carefully cut the polycarb sheet to fit the back of the stock duct so the round dryer duct would fit it. Routed it up into a hole I cut under the MAF air filter, where the original IC piping was, and attached the dryer ducting. A little spray paint prettied it up a bit and blended it in a little.
While technically not "Ram Air" because it's not sealed to the MAF, it does provide for a constant flow of fresh cool air while moving. It should also provide a slightly positive pressure to displace any hot under-hood air around the filter.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.
You must be logged in to view this image or video.