The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Rix Racing

New turbo setup, no start

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dabbdaddy

Proven Member
49
4
Mar 9, 2016
miami, Florida
Ok soo I f***ed up somewhere again and could really use some help

Swapped new turbo setup and added a afpr. After everything car turns on but runs like ass. Can't idle without throttle . Fouling 2 plugs almost every startup .
My afpr reads 43 when off (primed with ecmlink) when idle it's at 39ish . Isn't that too high for idle ?
I've done a BLT and fixed the ones I could find from not tightening couplers enough but same problem

Edit: went from 14b to small 16g running same tune, doubt the tune is the problem tho
Engine mods :
750 fic injectors
255 pump
Fuel lab afpr
Fp manifold, small16g , Megan o2housing.

Any input would be great thanks
 
Well here's a better pic of the engine bay .

I need to cap now the port at the red circle I also replaced the hose next to it.
And for the green circle that leads to my Watergate , hope that's right .
I re adjusted my fuel pressure to be at 43 exact on the gauge

Still waiting for my new boost leak tester and the new connectors . Hopefully that'll be it and get my car going again
You must be logged in to view this image or video.
 

Attachments

  • 20171129_143516.jpg
    20171129_143516.jpg
    395.7 KB · Views: 32
I checked the hoses you where talking about Chrysler kid and I just ended up pulling out the sensor (wasn't plugged into anything) and plugged the ports .
You must be logged in to view this image or video.
Hope thats the hoses you where talking about because that's all that's down there LOL
 
Yeah you can cap every vacuum opening on the intake manifold if you want but you need to leave the sensors plugged in, to make the check engine light stay off.

The vacuum diagram was posted earlier on page 2.

The blow off valve and fuel pressure regulator need to be hooked to the intake manifold.

I highly suggest putting everything back to factory orientation to make everything easier.


For now you need to cap the opening here for the vent valve you un hooked. You can get a vacuum cap or thread a bolt into the hose to make sure it doesn't leak air into the manifold
You must be logged in to view this image or video.
 
Last edited:
Went to AutoZone earlier and bought a variety of vacuum caps and plugged those few ports .
As far as unused sensors and CELs I don't mind them since I have ecmlink I just get rid of them .

Package for my connectors come in tomorrow so I'll post back when I get those connectors redone :D
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top