The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support Fuel Injector Clinic

ECUflash car won't start after ceddy mods full install

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

too_genecide

Proven Member
83
10
Jan 26, 2013
yuma, Arizona
I flashed ceddymods sd with big maps to the ecu and now the cat won't start. I set the injector scaling and latency before flashing.
When I turn the key I get clicking noises from behind the dash and the cat fires but won't run. Evoscan wont connect either. I can flash the basic ceddymods with no problems.
Im not setup for sd I just need the big maps.
resolved
I had downloaded the wrong rom.
maf with big maps is the one I needed
 
Last edited:
No cats Were hurt during the process.
I had downloaded the roms onto a flash drive and for some reason I didn't pay attention to the other roms in the download.
I now have a new problem with 1 byte load values dropping near zero while 2 byte load seems to stay accurate.
While 1 byte load is going haywire I get knock sum
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top