erikoberdorfer
15+ Year Contributor
- 153
- 39
- Sep 10, 2007
-
Akron,
Ohio
Hello,
I am trying to wire my autometer 4590 0023-12 fuel pressure gauge (autometer pro comp ultra lite) to my aem ems v1. I would like to be able to datalog my fuel pressure while under boost. According to the AEM EMS install instructions, I can use pin #74 (ADRC11- available 0-5v input). On the instructions, it is a "4th" connector on the aem ems- with nothing currently plugged into it.
1.) Is there another "harness" I need to plug into this plug- if so- where can I get it. If not- have people been just pinning a single wire to this input? The single wire idea seems a little shitty...
2.) What other tips/setup steps do I need to take to properly set up and log this parameter in a 30-1300 aem ems?
thanks,
Erik
I am trying to wire my autometer 4590 0023-12 fuel pressure gauge (autometer pro comp ultra lite) to my aem ems v1. I would like to be able to datalog my fuel pressure while under boost. According to the AEM EMS install instructions, I can use pin #74 (ADRC11- available 0-5v input). On the instructions, it is a "4th" connector on the aem ems- with nothing currently plugged into it.
1.) Is there another "harness" I need to plug into this plug- if so- where can I get it. If not- have people been just pinning a single wire to this input? The single wire idea seems a little shitty...
2.) What other tips/setup steps do I need to take to properly set up and log this parameter in a 30-1300 aem ems?
thanks,
Erik